Tweet
It should work fine,not what I would do,but fine.But then I just blew $1200 on the last build.
-
-
Ya i really dont have 1200 bucks... Hah. I have 1/8 rod so i could use that as i think you just said. I will try finding the props i have.When speed isnt the option, change your waysComment
-
You will need a flex cable and prop shaft.Not 1/8 rod
Like this http://www.offshoreelectrics.com/pro...?prod=ose-1085
Actually not like...THIS is what you will need.Comment
-
Ok. Could i use rod for mock up?When speed isnt the option, change your waysComment
-
Could i use rod for mock up?When speed isnt the option, change your waysComment
-
Sounds good. What kind of tube should i get? I will check at my hobby store and see if they have flex tubing because they have a boat section.When speed isnt the option, change your waysComment
-
Sorry Mason,I'm doing a build/paint job for someone on the side. You should just get your parts and then go from there.You could for now prep the hull.Sand all the old crap off,wetsanding works best for this.Just get it looking smooth for primer.Comment
-
He said he would take 20 for buy it nowWhen speed isnt the option, change your waysComment
-
Am I correct with the 4mm and bushings?Comment
-
I dont know yet. I will findout as soon as i can.. i will sand the boat down and clean it up.. also, how can i make a boat more bouyant?When speed isnt the option, change your waysComment
-
Any foam pool noodle around?Comment
-
No. I dont go to the pool much, i have the nose of the boat filled with foam tho. What else could i do... Also, can i run a water cooling from the rudder, to the motor, out the motor, to the esc, out the esc, and out the boat?When speed isnt the option, change your waysComment
-
That is the idea.Only in this order,From rudder to ESC,out ESC to motor,out motor ,out boat.If the nose has foam in it that should do it.Comment
-
Ok. After i finish putting the electronics in, should i fill the rest of the hull up?When speed isnt the option, change your waysComment
Comment