80+ mph 32" rivercat

[urbs00007]

i got 12 mph going from a 447 to a 457 red to 50. gives an idea of what cut down props can do. higher rpm and pitch will be the answer as you know.

what is red to 50.

[kfxguy]

what is red to 50.

Short for reduced to 50mm lol

[rude5150]

Good job.

[kfxguy]

good job.

lol

[rude5150]

Could u believe I hit 80 with my zonda with 1730kv 6s?

[flraptor07]

Could u believe I hit 80 with my zonda with 1730kv 6s?

Ya got a Video?

[Apophis]

Well. I just can't get it any faster.

Sure you can...........twins.

[Chrissharp]

I understand that you are already pushing a lot of rpm but do you think the motor/esc would hold up to an 8s run

[kfxguy]

Sure you can...........twins.

I havent seen a twin faster than mine yet...not saying there isnt one.....I dont like twins anyway. lol

[kfxguy]

I understand that you are already pushing a lot of rpm but do you think the motor/esc would hold up to an 8s run

Well.....I dont wanna chance it....and thats the easy way out lol. I wanna do this on no more than 7s.....and Im gonna do it tweaking stuff. Throwing another battery in it aint no fun!

[kfxguy]

Could u believe I hit 80 with my zonda with 1730kv 6s?

Good job.

[Rocstar]

I havent seen a twin faster than mine yet...not saying there isnt one.....I dont like twins anyway. lol

Boyd Marshall 102.88 MPH in a FCR Rivercat.....There's probably a video somewhere.

[kfxguy]

Boyd Marshall 102.88 MPH in a FCR Rivercat.....There's probably a video somewhere.

Twin?

[Apophis]

I dont like twins anyway. lol

I know, that's why I said it LOL
honestly if I were building one of these little guys it would be a single so I could run it in IMPBA P-Cat saw would be a challenge on 4s....

[kfxguy]

I know, that's why I said it LOL
honestly if I were building one of these little guys it would be a single so I could run it in IMPBA P-Cat saw would be a challenge on 4s....

Ahhh..lol. Yea I like my simplicity and less $$$ lol