First build... Cheap boat, lots of power

[srislash]

Sooo,which one is quicker?

[masonis1]

Well out of the line mine is. It doesn't cavitate near as much. Right up on plane compared to.about 15 feet for the blast. But the blast rides flat at full throttle where mine bounces... A lot. The blast is faster but can't turn the nose dives down.and the.boat goes under after any semi.hard turn. Mine handles better.and accelerates.better but.I need to.keep it from.bouncing.

Sent from my SPH-D700 using Tapatalk 2

[srislash]

It can be tricky with a mono.My DF 35" is still not dialed in.

[masonis1]

So where can I start? weight movement or strut movement

Sent from my SPH-D700 using Tapatalk 2

[masonis1]

The t180 is as cold as it was when I put it in afterm running full throttle for 15 minutes straight.

Sent from my SPH-D700 using Tapatalk 2

[srislash]

Do you have a current side pic of the strut.It should be parrallel with the hull.Run a ruler down it and see.You would be surprised what a difference a degree would make.

[masonis1]

Ok. It does seem to be at a downward angle.

Sent from my SPH-D700 using Tapatalk 2

[srislash]

That'll make her bounce.

[masonis1]

Should it be straightbwoth the transom straight with a flat surface on the ground?

Sent from my SPH-D700 using Tapatalk 2

[masonis1]

I have it as flats it possible can get. Ill test it. Wb weight?

Sent from my SPH-D700 using Tapatalk 2

[masonis1]

Hey, havent talked in here for a while. Remember that blast i.wanted to.beat. Here it is with almost same setup. https://www.youtube.com/watch?v=Tqfa...e_gdata_player

Sent from my SPH-D700 using Tapatalk 2

[masonis1]

Ok so I did some work because a new build is restarting me that I saw. I want to help him.

So still running a turnigy 2700 bl motor
Now a turnigy 60a esc,
I'll do a 2s test and 3s test coming up. I also did some work to help the boat ride better an to accept a new prop.

ImageUploadedByTapatalk1348104617.350480.jpg
Yes that's the miss geico prop
ImageUploadedByTapatalk1348104645.044196.jpg

Lipos being tested
ImageUploadedByTapatalk1348104689.423616.jpg

[Make-a-Wake]

First of all, awesome river to run in.........Beautiful!!

Secondly, that Blast runs well, all it needs is about 2-3mm more in prop diameter and its a ripper!

[masonis1]

Thanks, and how do you think this prop will do on this boat?

[Make-a-Wake]

Thanks, and how do you think this prop will do on this boat?

What prop?