another mean machine set up

[bustitup]

holy shoot batman! I just hope you had that thing securely flat on something while that stuff is curing! Nice work, boogieman.

lol...yes I realized before I started that when I set the boat down and something that only supported the tunnel it put a bow in the hull deck

[Brushless55]

Wow! is that CF or black glass?

[Brushless55]

This video is the reason why I bought my MM !

http://www.youtube.com/watch?v=XEjJRiPyEyM

[Rumdog]

Holy friggen EFF!!! that is one damn fast mean machine!! that is my idea of sport boating!

[bustitup]

ok, try lowered it to 2.8v, because I've also get the same result till I lowered it to 2.8v. See if there is any different.

Mel what are you using to program your 180?.....card or tx
if your using card do you have a pic of it?
here is what i'm using its ver2

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=380108553430&sspagename=STRK%3AMEWNX%3AIT&viewitem=&salenotsupported

[Mel279]

Mel what are you using to program your 180?.....card or tx
if your using card do you have a pic of it?
here is what i'm using its ver2


http://cgi.ebay.com/ws/eBayISAPI.dll...lenotsupported

I don't use any card,I just use the tx instead, its simple to program. So, have u set the cutoff voltage that I've suggested to u?

[bustitup]

I don't use any card,I just use the tx instead, its simple to program. So, have u set the cutoff voltage that I've suggested to u?

no not yet...i'm just putting the boat back together from tearing it apart

[Brushless55]

it.... is.... Finished!

[Brushless55]

My first run with my MM, and wow! Cats are so cool!

not sure if it looks like it is running through the water right?

my cog is at 9"

[DISAR]

Congratulations!

[Brushless55]

Thanks!

it seams very tight to the water, not sure if this is how is should run?

[bigpapa]

looks good may loosen it up a little

[bigpapa]

nice rooster tail !!!!!!!

[bustitup]

Thanks!

it seams very tight to the water, not sure if this is how is should run?

9" is just about right for that boat...I use 9 1/2"
but are you balancing it properly?....I measure off the transome towards the front of the boat and put a mark at 9" (in your casr) in the side of the boat...I use the table edge and drab the transome towards me 9 1/2" ..the boat must balance or teeter totter at the measuring point...just shift the batteries forward or backwords to get it to balance on the mark you made......instead of a table edge you can use something perfectley round like a broom stick centered on the mark you made

hope this helps....if you have it balanced perfect it should ride just right

[Brushless55]

In the photo is was set at 9"

I'm new with cats, and I love this cat!
turns sharp and runs super smooth..