hpr ct04 67 inch cat build

[avery]

yeah i take it easy on writs i let my dremel do most of work and i do it one handed most time it healing good though but dont think it will ever be like it was before they choped on it wow they went deep but thanks for caring

[avery]

my email is [email protected]

[Xfactor]

Alot of people write me sorry theres one space now send the pm. Im stepping out for about 30 min ill respond when i get back

[avery]

could you make room for a pm xfactor need to ask quick question

[LarrysDrifter]

Your work looks good,man.Hope you get better very soon.

[Xfactor]

Hit me up Avery.

[avery]

thanks larry im not as good as those other guys but i try man some of there stuff is of the hook nice ive been also thinking of paintjob was gonna do an airbrush decked out but now think just simple pin stripe type i alrdy have some pretty lime paint ao might just do lime on both sides and part of top with some pinstripe in middle since i might be getting her up and running in next month or so

[Tommy Gun]

i don't know if you have found a good servo or servo's but i have (2) hitec 300oz+ servos for sale in the swap shop for $50 for both and both are brand new!
great build!! ill be getting my HPR 233 soon ill have to post pics!

hope all goes well with everything man

[avery]

thanks for offer but money to tight for this month if you still have next month i will contact you

[Tommy Gun]

Alright just lettin ya know man, good luck

[avery]

well esc and motors came in on same day so now it time to get busy caint wait to get started tommorrow. still need some input from xfactor who has been great help thumbs up realy cait say how much the help is apreciated oh well off to start looking and doodling need screws for motor to mount them thinking of putting duct from scoop straight to fan on motor should help keep it realy cool

[johnf]

Heads up, I think xfactor may no longer be a member, just a guest.

[chummer]

What motors and esc's did you get?

[avery]

oh what happened to xfactor wasnt aware i got the panasonic motors he suggested and some esc brushed and need to disable the bec so i can pull more amps and not sure correct way to do this i took the red wire from plug that goes to reciever and ran motor in hand and the esc heatsink get to hot to hold in about 20 sec so not sure where to go from here you see my funds were limited he suggested this setup as he run a single in large boat and doesnt get hot and me running twin setup should see close to 50 mph the esc is a brushed 200 amp and i should be able to run 6s through it the motor seams fin but the esc is getting hot maybe i can water cool it dont know here r pictures

[avery]

200A EP RC Car Plane Brushed Motor Speed Controller ESC
High Torque Panasonic 12V 14.4V 18V DC Motor Hobby


those r what i got xfactor suggested i realy dont know but im commited to try and get them to work if not then boat will have to back on shelf for while till i get money for littlescreamers and swordfish 240s