1/6 scale Jetsprint boats and 30mm Jet drives

[axel]

Hi Mick,how is the progress on the units?
Over here in Europe there is also Interest!
My Hull is waiting for a unit :-) and the electronics are ready - it will be a Outrunner 1600kv and 1800watts output - so i can try 4S and 5S
I am very keen to see the difference to a Kehrer!
Please send me by pm pricing + p&p - I am in Germany
Regards
Axel

[mickieb49]

Hi Guy's
Good news , i have just recieved the impellers, should be getting mine running wednesday, i will post the video up straight after, providing everything goes well, i will release the jets for sale thursday.
Thanks for everyones patience
Regards Mick

[mickieb49]

I also meant to add, i will not be doing a plastic version of the hull, they will all be out of Fiberglass.
Mick

[TheShaughnessy]

Looking forward to a vid.

[bandanabob]

Following this close, very interested in one. The NQD got me hooked on the whole rc fe boat world. Keep up the great work !

[mickieb49]

Hi guy's, here is a few teaser pictures, first run will be Wednesday.
thanks for looking
mickhull.jpghull1.jpghull2.jpghull3.jpgimpeller.jpg

[mickieb49]

impeller1.jpg

[l8rg8r]

Do your jet pumps have a reverse cup

[mickieb49]

Do your jet pumps have a reverse cup

Hi, no they do not, they have turning and trim.

Ok guy's, just had a run, will post some video up on Youtube tonight. Went better than expected, so officially they are for sale , $115USD each plus postage.
Please note you will need to put these together yourself. Either PM me here or send an email to : mickieb49@bigpond.com.
Please include your address in your email so i can get a shipping estimate to you promply.

Hulls will be a few weeks off yet.
Regards Mick

[mickieb49]

Here is the video, was very happy. May be too small a hull though as it was very twitchy, my hull will be 610mm , should be more suited to this unit.

https://www.youtube.com/watch?v=v_6jAV8CORI

Cheers Mick

[mickieb49]

I have decided to put a introductory sale on for $95 USD , offer will end on 15th December, shipping is extra, but should be around the $25 mark to most countries.
PM me if your interested.
Mick

[mickieb49]

Hi Guy's,
The plug for the mold is done, just need to wetsand and a polish then i will be laying up the molds hopefully this weekend.
Regards Mick

[gsbuickman]

Hi Mickie. Do you have any plans on incorporating a reverse cup on your drives ?. Thanks

[mickieb49]

Hi Mickie. Do you have any plans on incorporating a reverse cup on your drives ?. Thanks

Hi Mate, as of yet i do not, i do have plans on adding a second stage though, but this may be a few months off though.
A reverse bucket on these little boats is mostly for looks, i have been running them for the past 10+ years and not yet have i needed one, will take the idea on though. It will complicate the whole rear cone/ trim arrangement , not to mention the extra cost on setting up another injection mold for it.
Thanks for your interest
Regards Mick

[mickieb49]

Hi guys, here is the finished plug20131207_163206.jpg20131207_163213.jpg20131207_163222.jpg20131207_163228.jpg

Will keep updating pictures as I get some progress.
Regards Mick