NIP Turnigy 180 A ESC & P.C.

[bigpapa]

[bigpapa]

by the way the name is todd (:

[Meniscus]

Ok, so make your "investments", I'll take these so called "investments" at half price later

[bustitup]

Dang Jesse! You're like a cat waiting to pounce!

When you receive and use the ESC, let us know how it works out! I've been curious about it but I'd rather somebody else risk their $$$ first!

I'll let you know how it goes in a few hours........getting ready to float this sucker right now

4s 8000mah Castle Neu 2200 kv motor, x442 prop and Turnigy 180amp hope to hit 50+

[bigpapa]

good luck keep us posted

[Jesse J]

[Punisher 67]

Nick I am Curious on your info , I have 3 that arrived yesterday just bench tested them and very impressed so far , hell they even have reverse

[bustitup]

well right now i'm trying to figure out how to program it.....I assume you do this out of the boat with a 6v battery pack......so far I have plugged in the battery pack and the esc and I cant get the led's to light up...acts like its dead...any ideas?

[Punisher 67]

well right now i'm trying to figure out how to program it.....I assume you do this out of the boat with a 6v battery pack......so far I have plugged in the battery pack and the esc and I cant get the led's to light up...acts like its dead...any ideas?

If the voltage is to low it will not arm , 2 to 6 cells or 7.5 to 22.5 volts

[bustitup]

ok I discovered that the lipos have to be plugged in...it then worked

[Jesse J]

[Punisher 67]

These have an onboard ubec and do not require a 6v receiver pack , in fact I can almost guarantee it might fry the unit if one is connected up

[bustitup]

These have an onboard ubec and do not require a 6v receiver pack , in fact I can almost guarantee it might fry the unit if one is connected up

so you think I should just use the internal bec and not a battery pack
'

[Flying Scotsman]

Peter, that is very interesting, you are stating that if you remove the BEC circuitry and employ a 6V receiver pack it will go boom. Or have I got this all wrong, as old age is creeping in.

Edit

Or are you stating that using a 6V receiver pack and the BEC circuitry connected, it will go boom, when you connect the LI-PO batteries

Douggie

[bustitup]

one more big question...should I set timing at its lowest