Easy water outlet

[Jeff Wohlt]

I'm iwth Jim...been using them forever. I have also used them for antenna mounts to slide my tube in. I usually now take a nylon bolt and lathe the hole in the center then bolt thru the hull then run tube thru it.

I do use shoe-goo on both side to lock it in and seal it.

[questtek]

Great idea...I am now using them for the exhaust cooling fitting on several boats. Antenna idea is also a good one, much easier and less weight that the current brass fittings I am using. Thanks.

[LiPo Power]

Hi
How do I remove the pin out of my rivet please?
I was trying but it's sitting inside so tite I will damage it if more force applyed...
Robert

[topolino]

Hello .. take a long rivet and cut the tip with a saw .. not just cut the tip of the pin .. cut a part of the body of the rivet is also

... then it is easy to get the pin with a pliers

pay attention in the first photo of this page where I have 2 rivets in my hand

[LiPo Power]

Hello .. thank you. That was easy...

[crabstick]

Hi
How do I remove the pin out of my rivet please?
I was trying but it's sitting inside so tite I will damage it if more force applyed...
Robert

I just hold the flanged side and tap the pin through with a small hammer

[LiPo Power]

I just hold the flanged side and tap the pin through with a small hammer

I did just that, it works great, thank you. Great idea for water outlet.
Robert