Your MG that started off as a hull

[macdon]

OUCH!!!
How and why did it happen Shawn?

[srislash]

I am still trying to figure that out.All should've went well.Something in the Swordy's.That is three of em'

[macdon]

Could you tell us what the setup was?

[srislash]

T-600,swordfish 200's and X447 DT'd props,all this on 6s.Swordy's set to "middle" timing and 8khz for PWM

[macdon]

It must've been some spike from the T-600?

How's the hull? Any other damages?

[srislash]

Logger says 110 amps

[macdon]

So a T-180 would suffice for a single T-600 then?

[srislash]

So a T-180 would suffice for a single T-600 then?

Yup, that should do it .As a matter of fact I think I will get two of them for the Komodo.I am not really willing to toss my Castle Ices into the fire.
It is possible that I got a backfeed from the internal BEC in the Swordy.It was acting up,well,not working any way.

[macdon]

Shawn - really sorry to hear about your flame out and hope your next setup would be trouble-free.

[srislash]

Shawn - really sorry to hear about your flame out and hope your next setup would be trouble-free.

No worries Mac.I was probably just rushing things to get it in the water and not thinking enough.But all this has me decide on a paint scheme: FLAMES

[lenny]

Hi Mac,
I still think I will try the t600 1400kv in my 36"shockwave on 4s and may be more.
It runs real nice with the 4074 2200kv,
But I want to hear how and see how the t600 will do.

And hears the same boat that was gas, Modded to FE,

That I am getting this stuff from that was never used yet for the big cat,
Welcome me to the dark side.
DSCN1110.jpgGas cat 4.jpgGas cat 3.jpgGas cat 2.jpgGas cat.jpg

[srislash]

So what is in there for batteries Lenny?

[lenny]

Hey,
Just click on more info on the right top,
Or go to top left and click 55 stepped mono.
It's a fine design boat on 6s and I think a 180a esc.

[lenny]

Hears a link,
To Scott build so far.http://forums.offshoreelectrics.com/...hless-question

[srislash]

Oh,ok,I had read it awhile ago.I thought maybe it was you'res.I just picked up a Proteus 524 3T so am deciding which way to go for voltage. 7s or 11-12s.