Prop Diagram

[Steven Vaccaro]

[bwells]

Broken tip on the left side?

[Steven Vaccaro]

I used a new prop, so it wasn't broke. I think it's the way I took the photo.

[Steven Vaccaro]

can you email it to me or try to attach it again?

[Fixitguy1]

Trying to find where to buy a b/s x440/3 I think it is a stainless steel for my Miss Geico 29 v3 all stock

[Steven Vaccaro]

I just sent you a pm.

[Fixitguy1]

Miss Geico 29 v3

I just received two Octura X440/3 props and both of them seem to have the same problem, they will not fit the drive dog.
it seems that one side of the slotted end of the prop is misaligned and if I removed about 1/16" from one side on the leading edge it would fit, but would be out of balance. what would you recommend.

[Steven Vaccaro]

I just received two Octura X440/3 props and both of them seem to have the same problem, they will not fit the drive dog.
it seems that one side of the slotted end of the prop is misaligned and if I removed about 1/16" from one side on the leading edge it would fit, but would be out of balance. what would you recommend.

Do you happen to have a picture? Sometimes the slots have to be opened.

[Peter A]

I just received two Octura X440/3 props and both of them seem to have the same problem, they will not fit the drive dog.
it seems that one side of the slotted end of the prop is misaligned and if I removed about 1/16" from one side on the leading edge it would fit, but would be out of balance. what would you recommend.

Use a 5/16" (8mm) od drive dog.

[ray schrauwen]

Yep use the little doggy.

[Fluid]

Removing material from the hub has less of an effect on practical balance than you may think. Removing 1/16" from the slot sounds like way too much however...


.

[Fixitguy1]

The drive dog slots are fine the tongue material is covering the the drive dog slot on one only

[Fixitguy1]

image.jpegimage.jpegimage.jpeg
Hope you can see this.