Atomik A.R.C. 58" Catamaran owners???

[rpedro]

thank you buddy

I get that... Trust me, I have NO connections to them at all... Minus buying one of their boats...

[rpedro]

Don't worry. Even I could figure out you didn't work for the company since you had to order one and are waiting for it. some people get worked up too easy.

Were you able to find one??? Mine will be in my hands Thursday, or worst case Friday...

[Jersey Crewmax]

Will you be posting video on this thread?

[rpedro]

Will you be posting video on this thread?

sure will... I should have it today or worse case tomorrow... I will be getting all my other supplies, etc in over the next week, and will be getting it set up and ready to go ASAP... will update with pics, videos, etc... hopefully everything works out...

[Finest Racing]

I placed my order today, should see it late September. I did not order the rtr.

[atechbh]

Just got mine. Works great on 6s

[forescott]

I bought one from tower when they first came out. Only run it a handfull of times on a zippy 5800mah 25c single 6s lipo. I bought it expecting the electronics to overheat and burn up right away and was planning to upgrade it, but it has been running flawlessly for me. No gps on it yet but it will run circles around my gas blackjack 55. The little 120 amp esc runs cool to the touch, but the motor runs pretty hot after about an 8 minute run. It is an air cooled outrunner in a sealed hull though, so I cant complain.

[iridebikes247]

Easy to upgrade too. Pop in a leopard 5698 910kv motor on 10s2p or 2028 castle for something fast.

[atechbh]

Just ordered a 2028 for mine.

[iridebikes247]

it will do the trick. have you ever done a carbon inlay though? the speed increase will be tremendous with that come harder crashes so reinforcements are always a good idea.

[atechbh]

Where is the best place to get the carbon cloth and what epoxy works
Best.

[Livewire121]

Where are you in Ontario? I get my cloth from Composites Canada here in Mississauga, and I use Z-poxy to lay it.

[atechbh]

I'm near kingston. Do I need to do the whole bottom and sides?
Do you normally do the underside of deck?

[Livewire121]

I'm sure you can source the cation fiber cloth locally.
Yes do the bottom and sides. Being that it's such a large hull, you can pretty much do the entire interior.
When I did my Ekos I could only lay so much, because I couldn't reach all the way in.

[atechbh]

Found the carbon fibre cloth locally but where can I find the z poxy?