Genesis catamaran ???

[FighterCat57]

Thanks for the shots guys! Yikes, not sure what stingers may work with this hull.

45mm wide sponson transom
24mm tall distal sponson transom
38mm tall medial sponson transom
99mm sponson transom overhang

It's not looking good for stingers. It's looking like struts, however the transom doesn't have enough room for all 4 bolts if using the same size strut hanger as installed stock.

Also note, the transom is not straight, it is convex curved.
________
Full Melt Hash

[Alfa Spirit]

I think that it will be very difficult to find 102mm long stingers for the Genesis.
In that case I' ll use 3/16" Metal Drive Shaft well glued in the hull and a flex between the motor and the metal shaft

[Jesse J]

so you adjust the drives from inside?

[Make-a-Wake]

Hey Jesse, i think he will have fixed shafts that can sit low by using the flex couplers inside.

[Dragonturbo3]

Could you extend the sponson (Spelling?) on the outside?

[Steven Vaccaro]

so you adjust the drives from inside?

Yes, the newer Jolly Cat drives are adjusted from the inside.

[ED66677]

In that case I' ll use 3/16" Metal Drive Shaft well glued in the hull and a flex between the motor and the metal shaft

yes you can! my 29" mono home made drive line is just like that!
tu veux la même en français Alain?

[Jeff Wohlt]

So how do you adjust from the inside? I thought they were epoxied in. It would be nice to see an inside pic. I had this set up on several monos and it seemsed fine. Even if they are not adjustable...it is not hard to get them set with a slight neg angle and would be fine. Then just adjust the CG with cells.

[Alfa Spirit]

Do you know where to buy stingers long enough for Genesis hull, parts like MHZ but cheaper

[FighterCat57]

That's a nice setup Alfa!

Why not just use dual struts?

http://cgi.ebay.com/aluminum-strut-1-8-shaft-full-set-/280428893152?cmd=ViewItem&pt=Radio_Control_Vehicles&hash=item414add53e0

________
Honda cb1000

[ED66677]

you've got to find someone who can make it for ya!...

[tiqueman]

Yeah Ive searched extensively and all the ones long enough have too large a mounting surface and will not work. Your more than likely going to have to scratch build something or run some type of struts. Personally, Id go the scratch stinger mounts, struts and twin cats just dont mix.

[tiqueman]

That's a nice setup Alfa!

Why not just use dual struts?
http://cgi.ebay.com/aluminum-strut-1...item414add53e0

I have one of those on a mini rio. Those are waay too small. For micro set ups.

[justintime2w8]

I am thinking rcmk hydrolift 1100mm hardware, struts and rudder. Mr. Park said they should fit.

[tiqueman]

HYDROLIFT!!! I didnt even thin of that. Great call Justin! Did you get specs on the stingers? Mount plate dims and lengths.. could be on the website.. I havent gone yet...