38" H&M Intruder twin to begin

[Jesse J]

Man thats beautious Jesse.............thanks

the Aluminum for the plates I won't be able to get till Saturday and thats hoping they have 1/16

At your service! if you don't get the 1/16" no worry, just if it doesn't slow you down or cause any extra bourbon.

[Punisher 67]

Jesse your fronts are machined , your rears are being redone right now . as you can see the reliefs are out way to far . Your fronts have 16 holes for the motor giving you maximum flexibility

[Jesse J]

YOU ROCK, MAN. Just got word (werd.) from the Egneg that my props are on their rockin way, and before long I will be pooling epoxy around my stuffers - indicating that the motors are successfully mounted and thhhhhheeeennnnnnnnnnnnnnnnnnnnnnnnn -- for the roost of all roosts

[bustitup]

even i am getting excited

[Punisher 67]

Jesse

Do you want the mount holes on the bottom the same way threaded 8/32 or how do you want them

[Jesse J]

Right, yes same way, but how about 6/32? don't need quite that massive of bolts, thanks for asking.

[Punisher 67]

I might also be able to get 1/16 Aluminum in town here some of the hardware stores sell it small strips up to an inch wide

Give me the exact dimensions you need 1/16 x length x width

[Jesse J]

2 @ 3.5" and 2@ 2.5" by 5/8" wide, and thanks again-again.

[Punisher 67]

1st rear correction finished the second is milling right now , you can see the difference

I will also see what I can find in 1/16 Alum Jesse

[Jesse J]

I like, I send you some $$ to help you out!

[Punisher 67]

Jesse I appreciate you sending that , it will certainly cover some costs but don't send any more , I will take it from here I want to see this succeed as much as you do . I really felt bad when it didn't come together for you the last time . I have to either make or find a mock 1515 to get the precise angle to trim the bottoms but no worries I have some idea's . This will most likely be send out either Mon or Tues and hopefully I can find some 1/16 here in town....Have a few leads there also...................

[Jesse J]

Peter, I had a suspicion you would have felt bad, but this is a team design and the players are in different countries, I would have been quite surprised if it had fit perfectly the first time! I appreciate your dedication to this and am sure it will work this time.

Do you want some super precise motor measurements and the cooler can as well? If possible I would like to use the coolers, but really probably wont need em.

Thanks again Peter!!!

[Punisher 67]

Sure sent the measurements , I am still going to build a mock motor to get the exact angle of deflection

thanks Jesse

[Jesse J]

motor: 2.685" long by 1.535" across
can: 2.190" long by 1.890" across (with nipple: 2.230")

anything else that might help? lemme know.
thanks Peter

[Punisher 67]

Thanks for the measurements , now to go make the fake motor...............

Oh BTW I did manage to find 1/16 x 3/4 x 6 foot flat bar in town so we are stylin there also