Twin powered carbon Rivercat build

[monojeff]

Funny it would have use to been ill have Jeff cut me a decal for the plate.
I been replaced.

Glad your having success in house and she is enjoying it and making things work!
I've got bigger fish to fry and carbon dust to make!

[kfxguy]

Funny it would have use to been ill have Jeff cut me a decal for the plate.
I been replaced.

Glad your having success in house and she is enjoying it and making things work!
I've got bigger fish to fry and carbon dust to make!

Lol, if you insist! I was almost going to have you engrave something but I wasn't sure what.

[monojeff]

I was thinking the same thing on the engraving!
You could even paint fill it for a neat new look.

[kfxguy]

Here's the plate with the voltage gauges. Turned out nice I think.

[Mxkid261]

Very cool those look handy, are those just tied into each of your batteries?

[kfxguy]

Very cool those look handy, are those just tied into each of your batteries?

Yes that's how they will be hooked up, individual to each battery.

[readyfireaim]

Lookin good. I'm really looking forward to seeing this baby hit the water!

[Mxkid261]

Is the plate with the volt gauges your ESC top plate also?

[Fella1340]

I'm liking the gauges, they look sharp and are good insurance as a last check before the deck goes on. I may use them in one of my boats if I ever get one in the water:-/ How many boats do you have in progress right now?

[kfxguy]

Is the plate with the volt gauges your ESC top plate also?

No, it's going to baca two layer trim plate assy. I'll get it done soon and post some pics.

[kfxguy]

I'm liking the gauges, they look sharp and are good insurance as a last check before the deck goes on. I may use them in one of my boats if I ever get one in the water:-/ How many boats do you have in progress right now?

Thx. It took a while to find these things. They are two wire and very small and adjustable.

O man. I got quite a list. I've been turning people down. I don't even have a running boat for myself right now except my mini Rivercat. The mono is pretty much done but I haven't bent tested it yet and programmed the Esc. Maybe tonight. I've had to turn people down lately. Getting too backed up. I had someone try to buy my mono and I haven't even run it yet. Same thing for this boat. Lol. I've had a few people try to buy this Rivercat. I'm anxious to see how it runs.

[boilo56]

kfxguy, is there any benefit running the strut tubes that close and down the center of the boat?

[readyfireaim]

Gonna get her in the water this weekend?

[kfxguy]

kfxguy, is there any benefit running the strut tubes that close and down the center of the boat?

Not that I know of. Just did it the way most twins I've seen are done.

[kfxguy]

Gonna get her in the water this weekend?

I doubt it. I've been preoccupied with other things and haven't quite finished it yet. I still have the hatch bolts and seal to do, work props, put battery trays in, cut flexes