MHZ 114 High End Build

[nata2run]

Latest updates....
There will be no more boat building as I'm changing HOBBY and moving!
GO TAMPA BAY LIGHTNING LEADERS ...... LOL
tampa.jpg

[flraptor07]

Latest updates....
There will be no more boat building as I'm changing HOBBY and moving!
GO TAMPA BAY LIGHTNING LEADERS ...... LOL
[ATTACH=CONFIG]131407[/ATTACH]

Well if ya do move to Florida I'll give ya the grand tour..

[nata2run]

Tempting offer!!!!
I have temporary changed my mind, so back to building again. I got all the hardware installed back on again, and also did the tubes for the steering cables. Came out good with no paint chipping LOL, next on lipo slide system and drill the holes for water outlets.

IMG_1527.jpgIMG_1529.jpgIMG_1531.jpgIMG_1532.jpg

[Shar75]

Great job! A masterpiece!Thanks for the detailed photos. The existence of such carbon parts you want in your Mystic 114.
Sincerely, Alexander

[spectre]

Latest updates....
There will be no more boat building as I'm changing HOBBY and moving!
GO TAMPA BAY LIGHTNING LEADERS ...... LOL
[ATTACH=CONFIG]131407[/ATTACH]

That boat is going to pop in the sun when on the water. Looks awesome. I would like join ur new hobby is there room for me, never new I enjoyed cheerleading

[nata2run]

That boat is going to pop in the sun when on the water. Looks awesome. I would like join ur new hobby is there room for me, never new I enjoyed cheerleading

Always room for people who share the same hobby lol, anyway... Got a fair bit done over the weekend. Will post a bit later on

[nata2run]

So, got the lipo tracks glued in. Not a fun part and also a bit messy. I have over time made a few tools just to be able to get it looking ok, and be able to align masking tape. Definitely the windscreen adhesive is still the way to go.

IMG_1537.jpgIMG_1541.jpgIMG_1542.jpg

[nata2run]

Almost Done!! got the rudder pull-pull system completed. only stuff left is drill and install the water out lets, install electronics and of cause the decals.

IMG_1546.jpgIMG_1550.jpgIMG_1551.jpgIMG_1552.jpg

[flraptor07]

So, got the lipo tracks glued in. Not a fun part and also a bit messy. I have over time made a few tools just to be able to get it looking ok, and be able to align masking tape. Definitely the windscreen adhesive is still the way to go.

[ATTACH=CONFIG]131511[/ATTACH][ATTACH=CONFIG]131512[/ATTACH][ATTACH=CONFIG]131513[/ATTACH]

That windshield urethane is some nasty stuff, we use it at my shop and it gets everywhere. Most of the time it gets places and you can't figure out how it got there!! Boat's lookin' awsome!!

[nata2run]

So far so good! Nearly complete. time to get her in the pool on the weekend to see if water tight!

IMG_1581.jpgIMG_1584.jpgIMG_1586.jpg

[flraptor07]

Kent, that thing is beautiful as all of your builds are! Can't wait to see it with graphics and all!!

[ECSURFER84]

what whats going on with the underside of the keel in picture three? looks like an unfinished gap?

[nata2run]

what whats going on with the underside of the keel in picture three? looks like an unfinished gap?

??? ??? where

[ECSURFER84]

page 1 of these posts before you painted, this picattachment.jpg

[ECSURFER84]

theres a gap in the transom offset, or is that just black marker?