Hpr 06 / 115 build

[Chrisg81983]

What do u need

[srislash]

I fear my cables are just too wide and that the angles are not going to work.Maybe overthinking. Let me finish assembly here and I'll post a pic in my thread.

[Chrisg81983]

Ok let me know if you need more pics

[srislash]

You have a much straighter shot than mine.Unless I make a major change(it isn't painted yet)

[Chrisg81983]

Yes its pretty straight the spread is 2.75 inches

[ManuelW]

Hi Chris,

great to see what you made out of the nice hull and all the parts. By the way are you satisfied with the Nokon PTFE liners for the hydraulics which I sent you?

regards,
Manuel

[Chrisg81983]

Thanks manuel and yes the ptfe liner is a perfect fit it seals the linkage cable so well I didnt even need to seal the end off. It wont leak a drop

[dasboata]

Chris sounds like you can go bigger on the props !

[Chrisg81983]

Hey chris whats up man I need some magic from u......anyway I ran today n got 83.3 on 6s and 94.7 on 7s soon I will hit 100 I hope

[dasboata]

I have the set of 457 sitting here I will do them up for you for next weekend !!!

[nata2run]

Chris, you may be safer to run a smaller 3 blade or more RPM?? to big a prop on that setup will surely get you

damn, your 2 mph faster than me LOL

[dasboata]

Chris, you may be safer to run a smaller 3 blade or more RPM?? to big a prop on that setup will surely get you

damn, your 2 mph faster than me LOL

The 57 will be cut down to 52 MM with some other work I think he will be fine !!! But then again I am a gas guy !!!

[nata2run]

The 57 will be cut down to 52 MM with some other work I think he will be fine !!! But then again I am a gas guy !!!

Yo Chris, I did spin the 57-52 with my 2250 @ low 30k worked great but a bit on the warm side of things. 2240's at high RPM, I don't know man? Those props have some bite. I run mine with a set of 2280's on a boat that's 20% bigger then what Chris is running now. I would stick to props in the 45-50 range. I think my 457-52 run even better than my 457. I get more speed with the 457's but also more heat.

[Chrisg81983]

Yeah kent I did some proo testing yesterday and a 447 or a abc 1616 is about max on 7s but chris I will have u make the cut 57's for me when I build my hpr 135 witb a bigger motor like some 2280's or some 30xx's nedd to look into it some more

[Chrisg81983]

Damn guys i am trying to get to lake but on a stupid 6 hr gas line due to the storm here in N.Y. / long island. Just hope by the time I get to pump there is still gas here lol.