47" Carbon/kevlar 2028 10s mono build.

[carlcisneros]

heck, 65mph even in E or F Mono (67 and 80-1.01 nitro in IMPBA) is fracken FAST!!!!!!!!!!!!

remember: to finish 1st, first you must FINISH!!!!!

[Make-a-Wake]

Here's the WOT Video!!!!!!.........I'm pumped!!

Quite proud as well.............thanks for lookin' gents!

[bruiser77]

Really nice work! Sounds great!

[ron1950]

nice ...what were the temps? looks like you are ready for durant open mono

[Make-a-Wake]

Thanks guys................temps were in the 125 range on the ESC and about 150 on the motor..........these big 2028's were made for bashin 1/5 scale buggies in the 100* dunes though.................its just gettin warmed up there...........

You got any totals on the class registrations?? PM me if you have some info Ron, thanks!

[Punisher 67]

Very impressive and all done with affordable parts . well done

[ron1950]

from what i can make out ...there are 4 or 5 p open boats and one t and 1 q...yours lol......

[BrianW]

Very Impressive! I have a new Sniper and DF90 here now on my table. Looking to making my first F/E boat.. Any body got any suggestions for the ultimate open mono boat

Brian

[Punisher 67]

Brian do a search on Sniper builds and start reading , there are a lot of great examples to go from

[Make-a-Wake]

New territory for me, i treated myself to a run after work in the lake i ran in for the vids............100yds behind my work.

[Jacked1]

That's fast! Good job!
This might be the last straw in my debate to buy a DF style hull for next year.

[Make-a-Wake]

Here's a pic of my homemade cap bank. I took the whole end section off of an old swordy 240hv that i fried by not allowing any waterflow due to the way i had it sideways and raised up in my Hydro.

Each set of three had to be dremeled out with the piece of the board still attatched, then i soldered the two boards together.............not alot of cap heat now since there are already 6 on there below it in the pic

[ron1950]

dont brake it before next week now!

[Make-a-Wake]

Anyone know if there is a burst rating on a Swordfish 240HV? I have an Octura x460/3 that i want to try as a step up from the 457/3 just in a SAW run to see what i can hit speedwise...................not gonna run it normally, just a few passes to see what she'll do. I think i may hit 75-77 with it..............

The SF240hv doesnt give a burst anywhere that i can see.

[Jacked1]

You should be good for a couple passes!
The Aquastar 240 says 280 burst which is the same as the SF.