OSE 40mm x 74mm motors

[Brushless55]

a clone of a clone of a clone. Chances are, they all come from the same place. Some with different components.

and some even say CASTLE

[Steven Vaccaro]

This motor is a 4 pole motor. One of the copies like all the rest out there. ALL of the memtioned motors are probably copied from the only licensed Neu design in the world. The Castle Creations motor.

and some even say CASTLE

And in the end, if you want the best of the best and the Original, buy a Neu Motor!

[Brushless55]

so is this motor no good?

[Steven Vaccaro]

The motors fine. But you have to realize its not a Neu. None of them are. There is a reason no one can keep Neu motors instock. They perform at maximum levels and take abuse.

[Brushless55]

I don't think anyone is comparing them to a NUE, that would be, uh not so smart

[tiqueman]

I have not run mine yet, but to chime in my $.02... I will agree that the soldering was less than I expected. Basically, the wires were tinned and then heated to the bullet w/ no other solder added. I re-soldered and will run it but not w/ a 45mm prop. I feel that may be a bit large for the KV. Im going to start w/ a 640 and go from there.....

[tiqueman]

Still have not run mine, but since Osprey hasnt chimed in yet after todays event, I will. Both he and I got Pursuit monos this past week. We raced today (club races) and although not getting eagle tree data and gps data, we did get temp comparisons.

My set up, Ettis 150 opto, stock Pursuit prop which is about a 42mm and a Leopard 4082 2200KV.

Ospreys set up, same boat, same prop T-180 and the OSE 2364 4074. By the looks of it, he ran a bit faster (within a mph) than me. Motors were about the same temp... actually his was a tad cooler than mine I believe. And MY boat was running looser than his. He ran the heck out of it for 3 runs... maybe we did 4, I cant remember. But he had no issues what so ever and the boat(s) hauled the mail! Im installing mine this week.

(Both of us re-soldered the bullets)

[egneg]

Hi Scott, do you know what timing was used?

[tiqueman]

I do not. Hopefully Osprey will chime in soon, if not, shoot him a PM.

Nice prop avatar!

[dasboata]

Do you have any more left steve I will take 1 thanks chris

[Brushless55]

Do you have any more left steve I will take 1 thanks chris

he may have these for sale on his site sometime soon
I was wanting one to run hard in my ERevo on 4s

[osprey21]

Hi Scott, do you know what timing was used?

Timing was set at 15 degrees.

[egneg]

Timing was set at 15 degrees.

Thanks, I think I may run this in a P-mono.

[ray schrauwen]

ping

[Steven Vaccaro]

I'll have a bunch more and different winds the beginning of April.