Free to a good home - ESC cooling plate

[Chilli]

Fried my Etti 150 today. I pulled the cooling plate of it thinking someone may want it. Excellant shape. Slight burnt smell.......

Plate is 1/16 thick aluminum, 1-1/2 inches wide and 2-5/16 long.

First contact gets it.

[Diegoboy]

Please... Me

[Chilli]

Man your fast. PM me your address. I'll get it in the mail on Monday.

[Jesse J]

Pray share your recipe for disaster. I have one too and feel like I am riding it on the edge. What were conditions, if you don't mind reliving it one more time.

[bustitup]

Pray share your recipe for disaster. I have one too and feel like I am riding it on the edge. What were conditions, if you don't mind reliving it one more time.

speaking of which...how did your turnigy 180amp work out ......did you get full power out of it?

[Chilli]

Last post on this thread.....

http://forums.offshoreelectrics.com/...ead.php?t=8439

[bustitup]

Last post on this thread.....

http://forums.offshoreelectrics.com/...ead.php?t=8439

whats that big black round thing inbetween the coupler and the tubber and where do you get them?

[Chilli]

I think your talking about the stuffing tub support. I made it with some leftover marine plywood I had laying around. I drew two parallel lines the width of a nickel on the ply. Rounded off the top and drilled an appropriate sized hole for the stuffing tube at 15 degrees. I also made the reciever battery tray out of marine plywood. If you cut a cross section, it would look like a T except with two vertical lines. One vertical support on either side of the stuffing tube. I spooge the gap between the verticle supports with construction adhesive before I epoxy it on and this adds additional support to the stuffing tube. I don't know if it's needed but it's something I do.

[Diegoboy]

It showed up today. Thank you!

[wolf IV]

Lucky........

[Chilli]

No problem Danny.

Make sure you make a sacrafice to the FE gods to remove any bad Juju I might of put on it.