ARC Motor

[bigwaveohs]

This is an ARC 1.5 turn, 2800 kV (ducted fan) motor that is very efficient at 2000 watts. Standard mounting holes and uses a standard 36mm water jacket. Complete with 5.5mm bullets installed. Ran once on a VS-1 and it was silly fast! Retails for $87.

• Dimensions: 36mm x 55mm
• Weight: 234g
• 25mm and 19mm apart mounting holes.
• 5mm shaft with flat
• 4 poles

36-55-1 shipped $55.
Send PM for details.

SOLD

[calcagno45]

PM sent

[LarrysDrifter]

Awesome motor. I have 2 of these and wouldn't run anything else. Priced right too.
The MPH in my signature is from these 36-55-1's.

[MSTHTD]

OP says this may be to much for the MG on 4s.. I'd like to try it out tho, what do you guys think?

[LarrysDrifter]

I run a twin cat. Rocks on 3s though in a single drive.

[MSTHTD]

I run a twin cat. Rocks on 3s though in a single drive.

What are your run times?

[LarrysDrifter]

On 3s2p, it was between 5 and 10 minutes. Should run good in an MG. Use 4s for a quick saw pass. It was cool running and a lot of fun on 3s. If I had a use for the OP's motor, I'd buy it. Arcs can take a lot of punishment. Warranty is great too. In my opinion, they are the next best motor to a Neu.

[ray schrauwen]

I would grab it if I had any spare money, excellent deal!!

[MSTHTD]

PM Sent

[LarrysDrifter]

Wise decision. More FE boaters need to realize the potential with Arc motors.

[MSTHTD]

Wise decision. More FE boaters need to realize the potential with Arc motors.

Never heard of em, but I'll take your word!

[ray schrauwen]

When you get it look at the thickness of each winding of wire. I've not seen many if any inrunners at all with that sort of guage wire. The 2800 is packed with wire from end to end also.

Allot of motor in a 36mm x 55mm package.

[fuse01]

do you use the 4mm bullets it came with or swap them out to 5.5 or 6.5?

[bigwaveohs]

Use 5.5mm. I'm running a 36-65-1 in an FE-30 and it runs very cool and very fast on 4S. Ray put me on to these motors and they are as efficient as the NEU's.

[MSTHTD]

Hopefully I'll have it by the weekend, so stoked to run it in the MG!