FS: 4 x Turnigy 6S 20-30C 4000mAh

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • vasy
    Senior Member
    • Dec 2009
    • 333

    #1

    FS: 4 x Turnigy 6S 20-30C 4000mAh

    2 are brand new = $45each
    2 have 1 cycle on them = $40each

    1 used has a black spot as you see, it is liquid tape, not damage.
    The heat shrink was loose so in my infinite wisdom I used heat gun to tighten it up. Worked fine on the 3 others but I brought the heat gun just a little too close and it shrunk a little too much leaving a small hole, about the size of the quarter. I covered it with liquid tape to keep the crap out.
    DOA warranty. You would have to ship it back for refund. I can send pictures with voltmeter if buyer wants.

    Spec.
    Minimum Capacity: 4000mAh
    Configuration: 6S1P / 22.2v / 6Cell
    Constant Discharge: 20C
    Peak Discharge (10sec): 30C
    Pack Weight: 650g
    Pack Size: 148 x 49 x 40mm
    Charge Plug: JST-XH
    Discharge plug: "Deans"

    Shipping for 1-4 in US/Canada. $20/$18
    Attached Files
    Last edited by vasy; 07-02-2010, 02:24 AM.
  • boatman cmbc
    Senior Member
    • Feb 2010
    • 159

    #2
    6s

    are u saying 85$ 4 all 4?

    Comment

    • vasy
      Senior Member
      • Dec 2009
      • 333

      #3
      Originally posted by boatman cmbc
      are u saying 85$ 4 all 4?
      almost :)

      Comment

      • longballlumber
        Fast Electric Addict!
        • Apr 2007
        • 3132

        #4
        Do I see silicone at the wire ends?

        Later,
        Mike

        Comment

        • LiPo Power
          DJI Drone Advanced Pilot
          • May 2009
          • 3186

          #5
          I use to do that to my lipos while back to keep the water out....



          Originally posted by longballlumber
          Do I see silicone at the wire ends?

          Later,
          Mike
          DJI Drone Advanced Pilot
          Canada

          Comment

          • vasy
            Senior Member
            • Dec 2009
            • 333

            #6
            Originally posted by longballlumber
            Do I see silicone at the wire ends?

            Later,
            Mike
            I do that to all my lipos to keep the water out....
            There is a lot of crap in it, so helps keep crap out. Not so much water, but the sand in it.

            Comment

            Working...