Say Chris how much weight did you put up in the sponson of you PT boat ?
NEW Florida Fast Electric Club
Collapse
X
-
Comment
-
I'm seriously thinking I won't be at Akerman next weekend. The heat normally doesn't bother me much but our last run about did me in. I just might take a break.
In other news, I figured out why three of my boats went wild last time. Bad transmitter which I have sent in for warranty work. I have used Airtronics radios in aircraft for almost 40 years with nary a glitch but the newest AT I bought for my boats is bad. Go figure, eh? In the meantime I bought an upgraded AT radio and am in the process of changing everything over. PITA!
Mini Cat Racing USA
www.minicatracingusa.comComment
-
Got a few things done this weekend.
LSH
Install new UL-1 motor
Make a bend adjustment to turn fin
Make a strut adjustment
Reposition Speedo to the rear
Back cut new m445 and reshape ABC 1716
Add 3 oz weight to rear of boat
STD 32” Twin Cat
Replace servo with new 645mg
Create new Z-bend push rod to decrease servo load
Put finishing epoxy on tunnel floor so Velcro will stick
1/8th Scale
Pull stuffing tube and make new strut nose cone
Make new shim to Increase strut angle
Redrill motor mount shaft hole for increased clearance
Relocate turn fin to inside of bracket and ensure it’s parallel to centerline
Increase adjustment slot for rear horizontal stabilizer
Now I gotta rebuild the P-Mono, rebuild the 43" MHZ twin and build the new TS3! Then I gotta finish the twin Genesis and finally build the Q-Sport SAWS boat that has been sittin here for 3 years.Last edited by RayR; 07-17-2011, 03:52 PM.Comment
-
I haven't been totally slacking but haven't done much more than pull shafts on the boats in that area.
Been concentrating on building another jet so I can get it out of the way and start on the proboat hydro. I'd forgotten just how much work goes into building a plane (especially an edf). I've been working on it for about 2 weeks now and am real close to being done with it.Comment
Comment