The biggest weaknes of the Swordfish is water. If you splash it, it's done. I killed the 1st one in my hydro when it got wet. You will definately need to make sure water can't get to it (other than the cooling lines).
NEW Florida Fast Electric Club
Collapse
X
-
-
-
It's still not totally waterproof but much better protected than it was. I added some glass along the floor across the bulkhead to the compartment where it's located and added a 1/4-3/8" spacer to get it above the floor as well.
If the boat sinks it will still get wet through the holes for the motor/battery wires and cooling lines but it's now pretty well protected from the water that comes in during normal running.Comment
-
so you didn't conformal coat the esc, just got it up out of the normal water?Mini Cat Racing USA
www.minicatracingusa.comComment
-
For you P-mono competitors. Any idea what speeds you are running? Im getting mine closer I think to being able to race. I got it moving yesterday much better than the Sunday before, GPS's at 53mph. But she has some handling issues and shes running a bit warmer than Id like. I back cut the prop last night. We'll see how that goes as it was the first one Ive done. Looks great, but who knows what will happen. Im hoping it will keep the speed, yet drop my draw and temps a little based on a conversation I had w/ Larry a few meets ago.
Just trying to figure out where I stand and how bad a beating Im going to get come Sunday.Comment
-
Comment
-
Comment
-
For you P-mono competitors. Any idea what speeds you are running? Im getting mine closer I think to being able to race. I got it moving yesterday much better than the Sunday before, GPS's at 53mph. But she has some handling issues and shes running a bit warmer than Id like. I back cut the prop last night. We'll see how that goes as it was the first one Ive done. Looks great, but who knows what will happen. Im hoping it will keep the speed, yet drop my draw and temps a little based on a conversation I had w/ Larry a few meets ago.
Just trying to figure out where I stand and how bad a beating Im going to get come Sunday.Comment
-
Comment
-
Bill,
Did you get the four pages of logos I emailed to you?Mini Cat Racing USA
www.minicatracingusa.comComment
-
Yep. Thanks Jim. Still haven't had a chance to show them to Cheryl yet though. Yesterday was a day of chaos at work with being short handed (staff at Miami boat show) and some computer issues.Comment
-
Comment
-
temps were getting upper 140s on the Seaking caps, motor was mid 130s, and batteries were 115ish. The bullet connectors were really hot, 5.5s were at upper 160s. On my 3rd outting one let go and became unsoldered. I think it was my fault though as I was soldering them the night before and one was giving me issues.. it just wouldnt flow right. I believe that was the one that came undone.
I had not adjusted the tabs, both sets were actually up a bit. Since running, Ive put the stinger back to neutral (was slightly down to keep the nose from lifting) and adjusted the tabs where the port side is down maybe 1/32 and the starboard is down just a tad more.
Heres a vid of mine and Osprey21 from Sunday. We both are running the same boat w/ slightly different set ups. He was running smaller props a bit lower speeds. His spins out at about 1:18, mine takes flight at about 1:30
Comment
Comment