Tweet
Now that i know this, i will only run S&B props... but they are a bit expensive.
-
-
I have run CNC props successfully on SAW setups, but only under smooth load and no turning. These were also very light builds, so if we take into consideration how easily they can bend by hand with just a little force, it would be better to run one of the other stronger metals.
However, this has got to be one of the most unique ways that I've seen to detongue a prop!
IMPBA: 7-Time FE World Record Holder "Don't think outside the box. Rather, refuse to admit that the box exists in the first place!"
MGM Controllers - Giant Power Lipos - ML Boatworks - Wholt's Wire Drives & Struts - Nano-Oil
Comment
Comment