My first attemp at 5s with my stock HK Pursuit:)

[Turbo Dan-O]

Oh cool! I would love to do something like that. I always thought that had to be "built in" to the ESC.

Edit: Just did a search for it. That is wicked cool! Be sure and post up your results!

[boilo56]

Just got back, I tried the X440/3 and the X443. It was too windy to go WOT, but on the X440/3 i got 70kph at 2/3 throttle. i didn't movitor the speed for the X443, but it looks crazy fast!https://youtu.be/s089W3KTqoEIMG_20150613_133425.jpg

[boilo56]

I have some problems with my new ESC. The led starts blinking after a few minutes of use. The batteries were full. See what i meanhttps://youtu.be/zb6Ifl_HHQU Please some help would be very appreciated!

[boilo56]

I have some problems with my new ESC. The led starts blinking after a few minutes of use. The batteries were full. See what i meanhttps://youtu.be/zb6Ifl_HHQU Please some help would be very appreciated!

Forget this, i solved it. It was LVC kicking in early.

[boilo56]

Hi went running the boat again, everything was fine! Here is the first complete run:

[boilo56]

Here is the second run:

[boilo56]

Here is the third run:

[boilo56]

And here is my last run of the day:

I wasn't able to go WOT on the first pass.

[martin]

With the front of the boat coming up like it is it looks like you have to much positive angle on the stinger ( angled up to much prop end ) or the centre of gravity is to far back.

[boilo56]

Good thing to know, i was thinking of lowering the trimtabs a bit, but adjusting the stigner angle seem easier. Thank you for your input!

[boilo56]

But it was so cool to see it riding only on the prop like that!!! I will try it again some time!6-14-2015_003.jpg

[boilo56]

With the front of the boat coming up like it is it looks like you have to much positive angle on the stinger ( angled up to much prop end ) or the centre of gravity is to far back.

Also, the COG is around 9''1/2 from transom. Batts were far in front.

[martin]

Cg needs to be around 9.75" in from transom as a starting point, re stinger & tabs angle start with them neutral ( parallel with the hull bottom ) & then adjust as needed.

[boilo56]

The trim tabs are at ''0''. Stigner is around 1 to 1.5 degrees positive from factory. Maybe if i move the ESC right behind the motor. Would it help the COG?

[martin]

Your cg is not far out, moving the esc back would help but I would take a bit out of the stinger angle & run again.