My rebuilt MC

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Jason4636
    Senior Member
    • Jun 2012
    • 654

    #1

    My rebuilt MC

    I tore this MC down about an hour after I received it in the mail. The guy I bought it from, here on OSE for sale area. The motor alignment was so bad I tore the whole boat down to bare hull. Then I filled the inside void with 2 part foam. Then I put a layer of CF in the tub and on the hatch. Next I cut the stuffing tube, and the new flex cable shorter. So I could slide the motor more towards the rear. I had to cut 4 strips 1/4"x4" 2.5mm CF plate, sanded them down on each side and bonded them together to raise the motor 10mm. Then I epoxied the motor mount, motor and a strip of CF fabric in to reinforce the motor mount.

    Leo 4074 2200kv, Seaking 180a esc,Traxxas waterproof servo, Turnigy 4s2p 5000mah 40c batteries
    Before
    1.JPG
    After
    3.jpg

    And here it is running today out at the lake. X442 prop, with the strut 1/4" up
  • Spencer154
    Member
    • Nov 2011
    • 74

    #2
    run a m445 she will eat

    Comment

    • Jason4636
      Senior Member
      • Jun 2012
      • 654

      #3
      I'm actually going to put it up for sale tomorrow. I just bought a miss gieco to rebuild. Plus I've started buying everything to build a FC Cheetah. An I have a FC Fantasm that Keith Bradley built, an propainter will be done with the paint next week. I can't wait to drive my Fantasm.

      Comment

      Working...