I tore this MC down about an hour after I received it in the mail. The guy I bought it from, here on OSE for sale area. The motor alignment was so bad I tore the whole boat down to bare hull. Then I filled the inside void with 2 part foam. Then I put a layer of CF in the tub and on the hatch. Next I cut the stuffing tube, and the new flex cable shorter. So I could slide the motor more towards the rear. I had to cut 4 strips 1/4"x4" 2.5mm CF plate, sanded them down on each side and bonded them together to raise the motor 10mm. Then I epoxied the motor mount, motor and a strip of CF fabric in to reinforce the motor mount.
Leo 4074 2200kv, Seaking 180a esc,Traxxas waterproof servo, Turnigy 4s2p 5000mah 40c batteries
Before
1.JPG
After
3.jpg
And here it is running today out at the lake. X442 prop, with the strut 1/4" up
Leo 4074 2200kv, Seaking 180a esc,Traxxas waterproof servo, Turnigy 4s2p 5000mah 40c batteries
Before
1.JPG
After
3.jpg
And here it is running today out at the lake. X442 prop, with the strut 1/4" up
Comment