Delta Force 35" First test, Fail!

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • marko500
    Senior Member
    • Aug 2008
    • 861

    #31
    Originally posted by millzee
    I'm just putting some pic's up on the "digout" on the build thread so you can see what I was trying. I now seem to think the 1/4 tube with no teflon sounds good, how do you attach the 1" of 7/32 as the bushing?
    I flared out one end of it so it would not slip down into the 1/4 inch tube and then put a drop of CA glue on it and inserted it into the end of the 1/4 inch tube.
    Get the stuffing tube set up and with a little trimming you are going to have one nice boat. As I said you are doing better then I have on some of my first runs!

    Mark

    Comment

    • Fluid
      Fast and Furious
      • Apr 2007
      • 8012

      #32
      Props smaller than 45mm are inefficient for this hull, their thrust cone is too small. Put the x450 on and run the boat for no more than one minute - use a stopwatch! Bring the boat in and check the temperatures on the motor, ESC and packs. That setup should give speeds in the mid-50s in a well set up boat.



      .
      ERROR 403 - This is not the page you are looking for

      Comment

      • millzee
        Ozzie Bloke
        • Nov 2010
        • 1092

        #33
        Originally posted by marko500
        I flared out one end of it so it would not slip down into the 1/4 inch tube and then put a drop of CA glue on it and inserted it into the end of the 1/4 inch tube.
        Get the stuffing tube set up and with a little trimming you are going to have one nice boat. As I said you are doing better then I have on some of my first runs!

        Mark
        thanks, I will set up this way, I've been doing a heap of reading and really appreciate all the help, advise and old threads all you guy's have on here.
        http://www.youtube.com/user/1millzee?feature=mhum
        "Gimmy Toyz for FUN"

        Comment

        • millzee
          Ozzie Bloke
          • Nov 2010
          • 1092

          #34
          just about to glass in the tube, any last advice or tips this is where I'm at
          http://forums.offshoreelectrics.com/...ad.php?t=21638
          I've done what marko500 suggested with the 7/32 tube glued into the 1/4" brass, it's all bent to shape and I've now made a ply board that I intend to fix to the three 5mm ply uprights that remain from my first attemp. This board has a cutout section just over 1/4" for the tube to come up through and I intend fixing two supports, 1 on the end of the tube and the other between the end and where the tube comes up through the ply.
          http://www.youtube.com/user/1millzee?feature=mhum
          "Gimmy Toyz for FUN"

          Comment

          Working...