Stiletto First Run w/New Boat

[ALD]

Received my new Stiletto yesterday. Assembled everything according to Manual. First Test run on (two) 2s 5300mah 25c hardcase today. My first impression of this boat is FANTASTIC. Drives better than I expected. In stock form runs pretty fast. Boat has alot of potential. It turns in both directions equaly great and it feels like it on rails at speed. I would like to thank Darin for designing such a beautiful boat. I still need to trim and tweak, but out of the box very impressive. My first boat out of the box that didn't break on the first run. Pro Boat got it right!

[ron1950]

sounds good to me i agree with ya about the boat looks and all...planning on getting mine on the water today hope i have as good a first run as u had. three of us all got them the same day here in mississippi and they are all waiting for me to test mine first lol.....i havent run a boat in 30 years !....

[jamespl]

get some vids up guys

[GP73]

Just got mine! She's beautiful!

I can't wait to get it wet now!

[AndyKunz]

Are you gonna leave that sticker over the cockpit?

Andy

[Darin Jordan]

Are you gonna leave that sticker over the cockpit?

Andy

Uugh!! That would be the first thing I'd pull off!!

[Flying Scotsman]

Mine will be painted by the idiot Scotsman and will include decals with the "more go than show prop company" and the "mangled prop company".
You have to be in the know to understand this epistle.

Douggie

[andym]

What props are working on this hull. lift, no lift, size etc?? Douggie what is motor KV, esc rating etc

[Darin Jordan]

What props are working on this hull. lift, no lift, size etc?? Douggie what is motor KV, esc rating etc

Andy,

Motor is an 1800KV version of the BJ26 motor. More RPM, a little less torque. ESC is a 60A.

Which props are best is still up in the air for me at this point. I'm liking what I saw from and X440/3, that's been backcut slightly and pitched up a little, but I'm still playing with it.

Looking forward to reports of what you guys think work.

[andym]

MM is the esc under rated,a 1716-10-50/2 round eared and 1.5m back cut. The 440/3 would get out the hole but get run down in the straights?? 1616-10-50/3 with same treatment would be worth a try

[Darin Jordan]

MM is the esc under rated,a 1716-10-50/2 round eared and 1.5m back cut. The 440/3 would get out the hole but get run down in the straights?? 1616-10-50/3 with same treatment would be worth a try

Interesting... I have those props setting on my bench, getting prepped! Can't wait to try them.

[andym]

Is this hull going to be available without the leg, esc, radio. Something like a pro package steering set up included but add your own esc, leg, motor, radio ??? This would be great as a lot of us would like to try the hull out but do not want the expense of gear we would not use with full on race set ups?? I think this would be a valid and profitable exercise

[andym]

If the hull does not like a lot of lift I have found rounding the ears with some spoon/cup at the tip with a back cut very beneficial.

[ALD]

Ran my Stileltto today, stock with (2) 2s 5300mah 25c and notice after the run of 4min everything was warm except the deans were real hot. What would cause that? Stock setup.

[andym]

You just answered your own question "deans" get rid of them, run 5.5mm bullet couplers.