"that" miss geico

[srislash]

Here are his words Mason,

If its a vinyl sticker, then definetly yes. They are all pores to allow water to escape. Use one table spoon of dish washing detergent per half gallon of water. Then spray on both surfaces. Apply together, and squegee water out. Wrap a cloth on the squegee so you don't scratch the decal. Then simply let dry over night.

[masonis1]

do.i apply the whole boat or just not the ride pads

Sent from my SPH-D700 using Tapatalk 2

[masonis1]

Sent from my SPH-D700 using Tapatalk 2

[srislash]

Just where you want to place the decal Mason

[masonis1]

ok. thanks shawn. ill try working on it tomorrow

Sent from my SPH-D700 using Tapatalk 2

[masonis1]

Hey shawn, like my foff rig?

Sent from my SPH-D700 using Tapatalk 2

[srislash]

Got to see it rip-her-up

[masonis1]

I have a video on my youtube.com/user/masonis1 it runs

Sent from my SPH-D700 using Tapatalk 2

[masonis1]

http://m.youtube.com/watch?v=77mNM-L7BQk

Been working on this beast while i couldnt do anythibg from my surgery

Sent from my SPH-D700 using Tapatalk 2

[srislash]

You need to stiffen the front springs a bit to slow down the flipping over.It is made for crawling so it is probably tripping on itself.

[masonis1]

I will do that. Hah i actually lossened them for this build. Opps. Also, now i jist got in from a run. I was punching it hard a.lot on the asphalt. esc and motor were both 150. thats high i think!. The esc got a little warmer from the first run but the.motor jist changed totaly. It was barely warm before. Now its 150... any.suggestions

Sent from my SPH-D700 using Tapatalk 2

[srislash]

What's the timing at?And how do you expect a SV2 to live under 4s?

[masonis1]

Timing is at 10* and i was going to swap the esc for a test

Sent from my SPH-D700 using Tapatalk 2

[masonis1]

What can i sell this ul1 motor for? have a guy looking at it

Sent from my SPH-D700 using Tapatalk 2

[srislash]

Look in the Items for sale.You should be able to find one so you can compare.