Hey everyone, I was running my MG yesterday when it just stopped working. I charged batteried to make sure I didn't have a bad battery, blah blah blah the usual check over stuff. I took it out, and it was definitely burned. Smells like a burnt esc does. Anyone else have any problems? I am going to send it off and get a new one I hope, because it is still under warranty. I will probably put a different one in, but what is a good replacement ESC?
Stock ESC burned up
Collapse
X
-
Hey everyone, I was running my MG yesterday when it just stopped working. I charged batteried to make sure I didn't have a bad battery, blah blah blah the usual check over stuff. I took it out, and it was definitely burned. Smells like a burnt esc does. Anyone else have any problems? I am going to send it off and get a new one I hope, because it is still under warranty. I will probably put a different one in, but what is a good replacement ESC?
What prop?
Stock motor?
* Seaking 120
* Hifei Swordfish 120
* Seaking 180
* Hifei Swordfish 200 -
If you did not change any from stock it will be replaced.
What was your set up?DJI Drone Advanced Pilot
CanadaComment
-
* Properly lubed shaft?
* Gap between the drive dog and the strut?
* Any half throttle or less then full throttle running the majority of the run?
* Any excessive turning/hard constant turning where the boat would be on/off plan often?
Any/All of those could lead to esc failure.Comment
-
You may be the 1 out of 100 that got a bad one. Horizon should cover it no problem, there customer service is awesome!Comment
-
I think Horizon will send you a new one if you call them....NAMBA20...Caterpillar UL-1, P-Spec OM29, P-Mono DF33, P-Spec JAE, Aussie 33" Hydro-LSH, Sprintcat CC2028 on 8s, PT SS45 Q Hydro, PS295 UL-1 power, OSE Brothers Outlaw QMono 4-sale, Rio 51z CC2028 on 8sComment
-
Yeah, I'll give them a call tomorrow, and I've never had a problem with them.
and Jim, I would run it until it started driving really slow, but I had the ESC programmed with slow cut-off, lipo, and I had greased the flexshaft. It was probably time to re-grease it, but it was running just fine and then cut out. I'll send it to them.Comment
-
Did you use programming card to swich your esc to lipo from NMH as this is set up for them as defoult?DJI Drone Advanced Pilot
CanadaComment
-
.NAMBA20...Caterpillar UL-1, P-Spec OM29, P-Mono DF33, P-Spec JAE, Aussie 33" Hydro-LSH, Sprintcat CC2028 on 8s, PT SS45 Q Hydro, PS295 UL-1 power, OSE Brothers Outlaw QMono 4-sale, Rio 51z CC2028 on 8sComment
-
It's easy with the card. http://www.horizonhobby.com/ProdInfo...ing_Module.pdf
Also set the motor timing to "HIGH" with the stock motor and make sure throttle curve is "LINEAR"
Yup you can run 5s. I been doing it for a while. Dis-able the bec and run a rx pack and change all the bullets over to 5.5mm or higher (stock 3.5mm & deans won't handle it)Comment
Comment