bad day

[jlr3rd1]

HELP!!man my black jack brushless cat fliped over on the pond the whole time the motor would keep running? so after leting her dry out , very little water in the boat. now when i hook up the batts all the boat does is BEEP AND BEEP??? i can still turn the rudder with the remote, but the motor wont run??? ANY IDEALS

[domwilson]

Is this with the stock setup? Make sure your batteries are fully charged. Check your motor connections. Double check to verify that the receiver is dry. You may have to open it up to let it air dry. Try reprogramming the ESC.

[jlr3rd1]

all stock except for prop, now the steering stoped working ??? after trying to reseting esc same thing batts are fully charged??? nothing but beep after beep???? why now the steering stop working??the receiver is dry it was in a balloon

[jlr3rd1]

when the boat was upside down and running wide open, could it have fried the esc???

[mtk]

no it is water proof I would wd 40 every thing andlet sit for a day or two that might help double check it might be a transmitter problem can you do all of these things then check back

[Christaphason]

You may have messed up the ESC as when the boat was running while upside down it was getting no cooling. I would try to reprogram the esc.

[jlr3rd1]

i have , with the batts off i held the remote with the throttle wide open then turn batts on all it does is just beep? and now no steering???

[jlr3rd1]

why did the boat keep running like that??? after the boat arms it BEEPS 5 singal and 5 double beeps over and over???

[domwilson]

Now the the rudder is not working? Do you run a separate pack for the receiver? If so, I suspect the receiver got wet. See if you can open it up and verify that it is not wet on the inside. Use alcohol or WD-40 to displace any moisture.

[domwilson]

why did the boat keep running like that??? after the boat arms it BEEPS 5 singal and 5 double beeps over and over???

I've had a few boats take a drink. Same issue. Sometimes drying out the receiver works. Sometimes, I've had to replace the receiver.

[jlr3rd1]

no not running a separate batt, and the receiver is dry??? OK NOW THE STEERING IS WORKING??

[domwilson]

Try the ESC from another boat. See if it works. I know this can be a little frustrating. But we can find the problem by the process of elimination.

[jlr3rd1]

my only other boat is a supervee?? and i never swaped out an esc???? i would hate to kill both boats lol

[domwilson]

This might help... http://www.offshoreelectrics.com/wiring.php

[jlr3rd1]

ok thanks will let you know thks for the help:)