Hey need help?

[jlr3rd1]

batt r good and have been cycled:) used grimm racer speed grease?

[sn00p]

My money is on the ESC try what iu said about full throttle when 1st connecting the batteries and switching on. Its a common problem.

I couldnt get good results with the programming card until i tried a different method.

Here try this 1st. connect up your batteries whilst holding the throttle to full. This will set the ESC min/max/rest of your TX throw.

Power up with throttle held then wait for beep. now quickly let go of the throttle. now remove batts. reconnect back up and i bet you get the prop to spin up.

[jlr3rd1]

i did my and over tighten to much and the boat would not run @ f t the guy @ my hobby shp get me back on the water:)

[sn00p]

Have you read this thread here....

http://forums.offshoreelectrics.com/...ead.php?t=8694