Help with SV27 and Fast radio

[Toypainter]

I am trying to set up an sv27 with my Fasst radio and have a problem. I am new to FE boats, but have been in RC for 20+ years.
Transmitter on, when I plug in the battery the ESC does a continuous beeping until I push the trigger to full brake. Then I get one beep (different tone than the the others), release the trigger- nothing- until I push full brake again, then the same single beep. Release trigger- motor starts. Will stop if I push brake, slightly accelerates when I pull the trigger. Runs continuous speed when I let the trigger go. I have tried setting trims, end points, everything I can think of, but nothing changes it. I even tried the ESC out of my brand new, never run UL1 with the same results.
Any ideas? I'm totally stumped!
T5hanks in advance,
Rob

[line6]

Reverse the throttle futabas come backwards. had this prob a few weeks back Bill-Socal straitened me out.

[Bill-SOCAL]

Also once you reverse the trim lower the throttle trim until it arms. Then you should be all set.

Every single Futaba radio that I have ever used, in airplanes, helicopters and boats, needs to have the throttle channel reversed for the ESC to arm. Go figure.

[longballlumber]

Agreed,

I had to do the same with my Futaba 3UCP (stick radio) when I ran the SV.

Mike

[Toypainter]

I'll give it a try. Thanks guys!

Rob

[Toypainter]

That worked. Thanks for the help guys!

Rob