Brushless wildcat

[minikitty]

also i'm probably not going to be running a lipo. just a custom built nimh battery pack

What about props?

[FighterCat57]

This esc you showed me has bad reviews of burning up. also how hard will it be to wire in two motors? Also what kind speed will i see from this set up you have shown me?

Aw dammit. Well... guess I'm not out that much munny... Shows me for not reading the reviews! (fortuantely I'm running it with much lower draw motors, so it might work)

[minikitty]

http://www.hobbyking.com/hobbyking/s...r_(Blue_Series)

Will two of these work with these motors?

http://www.hobbyking.com/hobbyking/s...idProduct=4196

[Alexgar]

this is what i run in my mini pricey but i prefer to be over rated than purchase twice

http://www.horizonhobby.com/Products/Default.aspx?ProdID=EFLA1040

[Alexgar]

maybe even this they are pretty small

http://www.horizonhobby.com/Products/Default.aspx?ProdID=EFLA1060

[Make-a-Wake]

http://www.hobbyking.com/hobbyking/s...r_(Blue_Series)

Will two of these work with these motors?

http://www.hobbyking.com/hobbyking/s...idProduct=4196

No, not enough amp capacity.

[FighterCat57]

http://www.hobbyking.com/hobbyking/s...r_(Blue_Series)

Will two of these work with these motors?

http://www.hobbyking.com/hobbyking/s...idProduct=4196

This might work, but is pushing it; http://www.hobbyking.com/hobbyking/s...r_(Blue_Series)

I'll let you know how the Hobbyking works out on 2s.

Mixed reviews, but price is right on this guy;

http://www.hobbycity.com/hobbyking/store/uh_viewItem.asp?idProduct=6459&Product_Name=Hobbyking_SS_Series_40-50A_ESC

[6S HYDRO]

if you wont be using lipos you wont be getting even close to the speeds mentioned probably not even 30

[minikitty]

What about if i ran 11.1v? Or is lipo the only way to go with the brushless to get highspeeds out of it.

[Make-a-Wake]

What about if i ran 11.1v? Or is lipo the only way to go with the brushless to get highspeeds out of it.

Since you stated you would be running nimh, 11.1 or so would be 9 nimh cells............lots of weight!

[Alexgar]

and low discharge rate out of nimh

[FighterCat57]

I plan on using two of these in parallel.

http://www.hobbycity.com/hobbyking/store/uh_viewItem.asp?idProduct=6540

[Make-a-Wake]

I plan on using two of these in parallel.
http://www.hobbycity.com/hobbyking/s...idProduct=6540

Great choice..............88 cont. amps!

[Alexgar]

this is the biggest i could jamb in the mini vee

http://www.hobbycity.com/hobbyking/store/uh_viewItem.asp?idProduct=9272

[FighterCat57]

This esc you showed me has bad reviews of burning up. also how hard will it be to wire in two motors? Also what kind speed will i see from this set up you have shown me?

Yep, have to use it on 2s if the motor is above 2000kv. 2s/2900kv should be good to go. There's a note on the specs.

It will be here tomorrow, so should have an update within the week. =)