Atomik barbwire prop and motor upgrade?

[stadiumyamaha]

Sky lipos.
I believe mine is the v2 with the two caps I it.

[Yiming]

image.jpgimage.jpg

3000kv scorpion out runner on mine.... 3s with seaking35a stock prop zero timing

The speed is .....good

Motor temp is hot but acceptable ...


Yiming
Singapore

[stadiumyamaha]

Anyone know how to program the stock esc ?

[Yiming]

I don't see any one selling program card for that esc



Yiming

[bayareaheli]

little quick inrunner motor mount i hacked up for the barbwire bit sloppy lol, just need to drill 2 holes on each side will bolt directly to the stock moulded in stand offs of the hull, going to try and do a 3d printed one next.

but just an idea if you dont want to hack up your hull

best regards

[ray schrauwen]

The stock prop is 30mm. I just fixed up a barbwire for my gf's nephew. I installed a S & B Octura 430 prop. Even though the shaft is only 3mm, when it butt's up against the drive dog and secured with prop nut, it runs balanced and square.

I wonder how that scorpion motor is mounted in one of the above posts... #17 ???

The stock battery needed to be destroyed since one or more cells went bad. Yes, it seems LVC is very conservative, safe but, it doesn't help cycle the pack well.

[ray schrauwen]

[ATTACH=CONFIG]116589[/ATTACH][ATTACH=CONFIG]116589[/ATTACH]

3000kv scorpion out runner on mine.... 3s with seaking35a stock prop zero timing

The speed is .....good

Motor temp is hot but acceptable ...


Yiming
Singapore

Try 15 degrees. Outrunners prefer higher timing.

[Yiming]

Ray

Will try that next time ...the boat jst too small for that motor...

My thinking is lower the timing to get the possible lowes speed I can get without
Piss off my buddy....

[Yiming]

Ray

image.jpg

[ray schrauwen]

Lower timing on an outrunner can add heat and not change much else.

Hard to tell if you bolted motor in with or without drilling holes in mount??

Ray

Will try that next time ...the boat jst too small for that motor...

My thinking is lower the timing to get the possible lowes speed I can get without
Piss off my buddy....

[Yiming]

I make some grove with file left and right on the stock motor mount.
Do it carefully untill u can pass tru the bolts for the motor.

[microboatdude]

little quick inrunner motor mount i hacked up for the barbwire bit sloppy lol, just need to drill 2 holes on each side will bolt directly to the stock moulded in stand offs of the hull, going to try and do a 3d printed one next.

but just an idea if you dont want to hack up your hull

best regards

You get this working?

[bayareaheli]

here is my modded barbwire with cut down sharpened balanced and cupped 32's first test in video is with the 431 second part of the video is the 631 prop which launches the boat like crazy out the hole lol

[bayareaheli]

You get this working?

No haven't finished it yet will finish it up this week :) just need to drill some holes and mount it.

[f.a.r.m.e.r]

Here is my highly modified barbwire

https://youtu.be/cKCvvq7zYL8