Motor Align 600XL

[DISAR]

The align does not have NEAR the mass of the kb45 xl. ITs mass is a little more than a 1515 neu so the kb is out of its league. That motor is not meant to push a 36 inch boat successfully on such a big prop

This means that the KB is better or the Align?

[ED66677]

I think the cooling fan is the only good solution.

yep! and they have a big big one on top of the heli

[DISAR]

ED here we talk about very important things for our boats and you make jokes with helis?

How about making a "heli-boat"?

[crrcboatz]

This means that the KB is better or the Align?

No not at all. It is just simply comparing apples to oranges. If one compares mass to mass the align does quite well with the neu 1515 on 4s. The kb 45 has more mass than a 1521 BUT it is only a 2 pole and the neu is 4 pole so I would think the neu would out perform it especially on 6s and Up.

I am going to use a 60xl align on 4s in my whiplash 20. The motor is 6 pole and is lighter than a 1515. Am using a wire drive with it too. Will be using a cooling coil and a fan for it.

I have a 650l Align ordered. It has a 6mm shaft and a kv of 1220. I am planning to use it with a tranny on 4s for a larger boat. it is 46.3mmx69.9mm so it has a mass very close to the kb45.

Curt

[ED66677]

ED here we talk about very important things for our boats and you make jokes with helis?

A heli-boat? with what? the main rotor as prop and tail rotor as rudder? ho noooooooooooooooooooooo!
I tell you what, it took me more than a year to get my boat fast, it took me a week to fly and just hover with my heli, the heli is so easy to setup compared to a FE boat! I'll keep the boat the way it is and mess around with float on the heli