Recomended RPM range explained

[Crash]

6 to7 mph faster but, boat is not set up to go beyond 70mph
Its wants to fly

[Crash]

rock n roll man

Do you think its worth it to try 8s with 46mm prop to reduce amp draw? It will still be in upper 60s mph

[photohoward1]

Bring some marshmallows on 8s


Sent from my iPhone using Tapatalk

[Crash]

Bring some marshmallows on 8s


Sent from my iPhone using Tapatalk

ok. thanks for that ;0

[Nikolas Andriop]

What esc do you have??

[Crash]

Sf 300 x

[Crash]

DID A bench test of the 8s
Rite away the set up got hot, that's not in water . just a couple of pulls to get data..
It only spun 35k rpm and pulled over 300 amps. Seem like that's not rite. No load and 300 plus amps. I have to look at it tomarrow Again.
I'm starting to think that this motor that Chris fine sold me is a 1650kv not 1750kv

[Prodrvr]

Which motor is it?

[Crash]

Which motor is it?

Tp 4060

[Crash]

DID A bench test of the 8s
Rite away the set up got hot, that's not in water . just a couple of pulls to get data..
It only spun 35k rpm and pulled over 300 amps. Seem like that's not rite. No load and 300 plus amps. I have to look at it tomarrow Again.
I'm starting to think that this motor that Chris fine sold me is a 1650kv not 1750kv

I used one 5s lipo and one 3s lipo
Obviously not. A matched set...is that a problem for the esc?

[Prodrvr]

As long as the esc can handle 8s, you're good.

[Prodrvr]

Tp 4060

What's the max voltage for that motor?

[Prodrvr]

I looked it up. It's good for 8s so I'd go with that.

[Prodrvr]

I have two TP 4070 2080Kv motors that I'm throwing in a Zonda build. They're rated for 6s max, so that's what I'll be running them on.

[fweasel]

What timing are you using with that TP 4060?