Didn't I mention to use a waterproof bag? It's "water resistant", but it has always worked for me after drying it out with a blow dryer, etc when it got water inside. Got mine wet a couple times and worked fine every time.
On top of that, seal those buttons and rubber seals near the buttons with some good waterproof duct tape or something for extra security. Maybe even go over the board with some corrosionX...
Yea you did. I went back and read that. Well it says waterproof in the instructions. How if it's not even sealed? Lol. My whole point. I sealed this one. Try again tomorrow in the Rivercat.
32" carbon rivercat single 4s 102mph, 27” mini Rivercat 92mph, kbb34 91mph, jessej micro cat(too fast) was
Comment