MGM COMPRO ESC's

[Livewire121]

You're very right, because I can run the motors in wye and use 8s to power them.

[jj2003]

JJ I hope you don't mind asking some of the same questions regarding MGM controllers? I'm looking at getting a pair for my HPR 115. But I'm also not sure as which ones to get, I'm looking at the TMM 25035-3 for Race Boats X2-SERIES PRO or the TMM 28026-3 for Race Boats X2-SERIES PRO

My current set up us as follows;
AS26-150BL-EvoII esc's
Lenher 2240/7 motors
Dinogy 65c 6s 5000mah batteries
Prop Shop 5014 props

Any help or advice is appreciated.

Not at all Livewire121, I think the more question's we ask, the better our understanding of them will be. Seeing as they seem to be the the next best thing or possibly better than the Shultze's, I think we all should know if we are building a top notch hull. Thanks for chiming in!

[Livewire121]

Thanks JJ! My current set up is working fine, but I'm near the top of my esc's capabilities, and I want some more head room.

[flraptor07]

I'm sorry I jumped in there when you directed the question @ JJ

[jj2003]

I'm sorry I jumped in there when you directed the question @ JJ

None needed Flraptor07, the more the merrier!

[RaceMechaniX]

A 2240/7 on 6S is already a pretty sporty set-up. The 28026's should be good, but like mentioned they will not go above 6S. A 2240/7 on 8S will pull more than 280A on hard accels which will likely trip the ESC limiter, but it's possible.

The AS26-150 are pretty good ESC's. Are they not working?

TG

[nata2run]

The 2240/7 on 6s - 7s is a nice setup. I would go the 250-35 MGM's just for the fact that you have options to run up to 8s. The AS controllers is to this day one of my favourite. If you can get your hands on a set of AS200, you would be set!

[Livewire121]

@ Tyler the esc's work flawlessly, it's just that I'm pulling their maximum continuous amperage, and working them pretty hard.

@nata2run Modellbau has been out of stock on them for quite some time. Also I picked up a pair of their LiPoSavers, and for some
strange reason one of the esc's won't arm when it's connected to it. I've tried everything to get the to work, but still nothing.

[jkr]

If understand correctly you run one motor in this hull?

ESC?