I am looking for a good setup Deltaforce 33 " cyberstorm.

[lenny]

Well it all looks pretty good,

But that is a lot of wire in their and I think it should be shortened up.

The more wire their is the more resistance and heat build up at Cells, Esc , Motor, and Connectors,

But you say all temps are just about at 90*f and that is very good.

But how long did it run to get to those temps ?

How much run time do you get out of those 4s 70c 6600 mah packs and what are the end run temps on that setup ?

Also why is the water tube so long that is on the port side exit ?

Was that for testing for leaks in the setup ?

12426349.jpg12426350.jpg12426348.jpg12426352.jpg

[SSchevy98]

Here is video.

https://www.youtube.com/watch?feature=player_embedded&v=_-xsFrhHEDk

[lenny]

Hears some info for the water proofing stuff.
What where you trying to water proof in the boat ?

http://forums.offshoreelectrics.com/...rvo-water-test
http://forums.offshoreelectrics.com/...st.&highlight=

[SSchevy98]

Hi Lenny,

Sanwa mt4 telemetria transmitter receiver.

Do you like the video?

https://www.youtube.com/watch?v=x3tKtpruHog&feature=youtu.be

Hears some info for the water proofing stuff.
What where you trying to water proof in the boat ?

http://forums.offshoreelectrics.com/...rvo-water-test
http://forums.offshoreelectrics.com/...st.&highlight=

[lenny]

Yes looks good,
I see from some of your other video's the boat is getting some air time to.

[SSchevy98]

New watercooling jacket for lehner 2250/9 motor





What do you think that watercooling jacket?


By the: Hampton RC.

[lenny]

The jacket is nice but the nipples suck,
They have a very small ID to them.
I would use some other nipples like the one's on the leopard jacket or bigger.

[SSchevy98]

Lenny,


Are they better?

http://www.offshoreelectrics.com/pro...prod=etti-a029

Why the need to change a better place?

[tlandauer]

Lenny is right, these fittings are on the small side, change them if you can, having said that, I like the machining of HRC jacket, the channel that holds the "O" rings are deep and provides a secure hold so there is little chance that the "O" rings will dislodge while the jacket is being installed.
What I do is unscrew the fitting, look into the inner hole on the hex , mark a line across on the outside top of the brass hex with a Sharpie marker where that hole is oriented, put the whole thing back but ALIGN the marking with the nipple. Also don't screw down too tight as the fitting will protrude the underside of the jacket, in extreme cases it will touch the motor can and reduce water flow to near zero, don't ask how i know...

[lenny]

Hears a little info on what I am talking about.

http://forums.offshoreelectrics.com/...ubing-question

Lenny,


Are they better?

http://www.offshoreelectrics.com/pro...prod=etti-a029

Why the need to change a better place?