Cutting carbon for transom

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • shctexas
    Senior Member
    • Jan 2011
    • 156

    #16
    Originally posted by Cooper
    I just use reg craft sissors, check out my post , MADD Catt I addressed cutting clean edges there, I'm on phone right now so it's hard to type
    I had the same dilemma but stumbled across a post here that suggested using spray adhesive to tack fiberglass cloth to the back of the carbon fiber. i tried it works great. I used a light fiberglass.

    Comment

    • Cooper
      Fast Electric Addict!
      • Jan 2011
      • 1141

      #17
      Yes in certain situations this works great. I think I used 1/2 oz Fiberglas. A very light "mist" of the spray adhesive is all that is needed.

      Comment

      Working...