newbie build.....

[smm_cbf]

i have to have the vent right in font of the rear end of the motor. im going to run the boar today with the 3 turn, with no top, and then i can decide whether or not to do a top with water cooled instend. ill try to get a vid for ya guys.

[crazzy maxx]

video yet?

[smm_cbf]

got out there, and the boat just stoped right in the middle of the water. turns out the connector inside the tamiya end on the battery fell trough alittle just enough for the battery not to be fully connected, so im going to try tomorrow, and see if i can't get a clean run.

[crazzy maxx]

lets hope!

[smm_cbf]

got the vid, at the end the little thing that hold the prop the the shaft comes loose....you can see and hear it.(well i think thats the problem, have't looked at it yet.)

http://www.youtube.com/watch?v=hvq04WtvtVs

[smm_cbf]

turns out it was the cupler, it was slipping for some reason??

[crazzy maxx]

you didnt tighten it enough. it happened to me about 4 times until i renched the hell out of it