FE conversion for the Segad 58

[Doby]

I just put that same motor in a 42" Cat on 10S...hope to hit the water this weekend...I'll let you know how it goes.

[Rob DeAngelis]

I just put that same motor in a 42" Cat on 10S...hope to hit the water this weekend...I'll let you know how it goes.

Super POWAAAAA!!!!

[Make-a-Wake]

Rob, what is this x600 prop you want to use? I think you need more diameter and less pitch for that large hull...............something in the x455-x460 range.............start on the smaller end of a range you decide on, Run it WOT for 45 seconds and bring it in to check temps on batts, ESC and motor.

[JIM MARCUM]

Lookin good Rob. JIM

[Rob DeAngelis]

http://www.horracing.com/product_inf...d202m3h0vc8363 Here is the mount I chose after hours of searching... It should work out just fine...

[Rob DeAngelis]

And heres the rudder I chose to work with... http://www.horracing.com/product_inf...d202m3h0vc8363

[h2o 1]

Kintec has that same mount.Looks rock solid!Nice build too bro!That thing should be a beast!!

[Rob DeAngelis]

Well the hatch is done... It came out good and strong... Now just waiting on my parts...

[Rob DeAngelis]

just imagine this.... 032.jpg duh I know they are dif motors... But back to reality, heres my real set up... Lep 5698 910kv and a sword 240... 036.jpg 034.jpg fjirjgf 002.jpg

[JIM MARCUM]

Rob, here's how I did mine: 1/8" aluminum, hole snug enough to keep H2O out. I just scribed a 1" circle on some 6061 scrap, cut it in half, drilled & countersunk 2 holes, deburred & sanded the edges, and epoxied them on. JIM

[JIM MARCUM]

Nice tats Rob.JIM

[Rob DeAngelis]

looks like a plan.... Thanks again Jim...

[JIM MARCUM]

As always, you're welcome Rob. Hey!!! We big Segad guys gotta stick together. JIM

[Rob DeAngelis]

As always, you're welcome Rob. Hey!!! We big Segad guys gotta stick together. JIM

[Rob DeAngelis]

Still waiting on parts...