What motor in a 42" Mono??? (DF MKII
Collapse
X
-
Sorry about the link.this is the working one.I dont know about the top speed because it is the first test run i deed with the boat last sunday.But from what i see 65 to 70.
http://www.youtube.com/watch?v=xnkGl1gNV6s
What mount and water jacket are you using?Everything that has a beginning, has an EndComment
-
I will have better results after next weekend about the top speed that i will do some test with a gps on,some propellers,and i hope flat water conditions.The mount and water jacket that i use is from horracing and they are perfect.You can also try the large rudder and the stinger version 2 from the same shop.If you are going to play on sea it is better to install trim tabs and turn fins also.It will help you to have the boat on the water and not in the air!!!!Last edited by coolmind; 03-20-2012, 06:46 AM.Comment
-
There's a cc1717 for sale in the swap shop. I'm using one in a 41" mono and a x447/3. Awesome motors!
Sent from my T-Mobile G2 using TapatalkComment
-
Comment
-
Sent from my T-Mobile G2 using TapatalkComment
-
This is my 2nd ever build plus it will be a restore as the boat is pre-owned by a nitro racer.
I will start a build thread soon.
Oh and what is your run time?Everything that has a beginning, has an EndComment
-
Thanks for the vid. Your boat looks nice and trimmed. I was kinda hoping for 60MPH with this build but I don't want to push it.
This is my 2nd ever build plus it will be a restore as the boat is pre-owned by a nitro racer.
I will start a build thread soon.
Oh and what is your run time?
Sent from my T-Mobile G2 using TapatalkComment
-
The speed is possible. Scorp has a cc1717 in has vadar hull and it hit 60mph if I'm not mistaken. With better cells and a bigger prop I'm sure my speed would have been really close to your goal. I'm actually going to drop down from 6s2p to 5s2p and increase the mah to 12,000mah. I'm looking for less speed and more runtime.
Sent from my T-Mobile G2 using Tapatalk
I have a lot of work to do on this hull before I start putting anything in it. I cleaned out the inside today, awful job after nitro use.
Removed old hardware, gotta rip out old stuffing tube, needs a few crack repairs, re-enforcing and a paint job.
I'm using this KV guide for voltage.
So if I was to choose between the 1320kv or the 1000kv HK Motor / 6s or 8s set-up
The 8s set-up would give me slightly higher RPM thus giving me a slightly higher speed?
I have this huge prop that came with the DF MK II but I doubt its any good for FE use
How big a prop can the 5692 motors swing?
4s batteries as directed above from scorp / make a wake. Minimum capacity? and with what C rating?
Most higher capacity batts seem to be 30c or less.
Thanks for the helpAttached FilesEverything that has a beginning, has an EndComment
Comment