Amp measurement increasing

[carlcisneros]

any one have a good way to boost the amp reading capability of the V4 Eagle tree logger yet?
(greater than 150Amps)

thanks

[srislash]

Post #27 in Stevens 10s rigger Carl.I have it bookmarked but can't seem to copy it for ya.I have an ET on the way as well.

[Chilli]

What voltage packs do you want to use Carl??

[carlcisneros]

just a couple of Eveready D cell batteries is all Mike,,,,,,,,,,,,,,,, ROFLMAO!!!!!!!!!!!!

[carlcisneros]

just kidding, will be doing measurements again on the 6S 300A and the proto type 8s 240 ESC's

[Chilli]

I'm glad you edited that first post. I was scratching my head. LOL

Thats alot of juice for any data logger!!

I was going to offer my Hydra Ice (with data logging) to to get a base line on what the motor and prop is drawing. I know the older Hydra's didnt like 6s very much. Havent heard too much about the Ice series. I pushed over 300 amps peak through that sucker on 4s in my oval trials boat.

[carlcisneros]

I can see that for sure Mike.

I have the ET V4 and I know some one here had it set for 300A useage.
now I know what was done to get it. :-)

I still have the mini 400A clamp on unit from the Mil. but it is getting old and in a boat, not the best of worlds to run it in.

[ManuelW]

I can't say it for the eagle tree but here in Europe we have the UniLog System from SM-Modellbau which is available with a 400A shunt for current measuring. These 400A are nominal, I've seen logs around 550A peak currents.

best regards,
Manuel

[jcald2000]

http://forums.offshoreelectrics.com/...s-rigger-build

Posts # 27-30

[carlcisneros]

found the section in Steves 10S rigger and got the pics on how to do the mod
to the Eagle Tree,

Mike, where did you get that binding wire you gave me?