Turnigy T-180 users please

[Simon.O.]

For all of those that have a T-180, can you please shoot me the following dimensions.
I have attached a pic to show where I mean.
Thickness of the unit over the fins between the cooling tubes.
Width between the motor wires and the cap bank.
Overall width, green line

Thank you to anyone who may help me

[millzee]

The height from the bottom to the top of the fin in the middle of the cooling lines is 28mm. The width between the caps and the wires is the same as the plastic bottom of the unit, 50mm. The overall width with over hang from the front of the wires to the very back edge of the caps is 76mm.

[scotthend21]

Hello Simon
your green dim= 2.7 (68 mm ) board dim
22.9 in ( 71.7mm) to capacitor end
Red dim
2.13in (55.2 mm)
totalthickness 1.10 in ( 27.11mm)
bottom to center of hoise barb0.84 in (25.00 mm)

Hope this helps

[Simon.O.]

Thanks guys, now I have what I need

[properchopper]

Simon,

I don't know if this helps, but when I had to stuff a T-180 into the confined spaces of my Tunnel radio box and have the wires and cooling lines line up in a convenient manner, I re-did the cooling fittings with some right-angle banjos from Kintec. I did have some problem unscrewing the old fittings on one T-180, and the last one I got, the stock fittings had some sealant around the tubes so I didn't try to unscrew them. Hope this might help !