Twin drag cat

[Doug Smock]

LOL It's ALL fun Chris.
I started out as a scale boater myself then got the speed bug. It's been all down hill since.
Doug

[ScarabChris]

LOL It's ALL fun Chris.
I started out as a scale boater myself then got the speed bug. It's been all down hill since.
Doug

Hey Doug, definately all fun. I'm sure you have seen my 54" Fountain build. Its the perfect combination of scale and all out speed. It looks like a real Fountain (especially once I get the wrap on) and at 30 pounds RTR it aint doing bad at 60 MPH.

[Brushless55]

What about twin CC1520's on 8s in this 35" hull?

[dasboata]

What about twin CC1520's on 8s in this 35" hull?

You want to buy my hull and try

[seedoobob3]

Hey Chris, Peter is building my twin mount side by side 1717's now, set my rails to 6" to get both centered betwwen rails, straight out stuffing tubes to twin inline strut/rudders from aeroM, he does a great job.

[dasboata]

Hey Chris, Peter is building my twin mount side by side 1717's now, set my rails to 6" to get both centered betwwen rails, straight out stuffing tubes to twin inline strut/rudders from aeroM, he does a great job.

I e mailed him I not sure I am going to go threw with this hull I have been told it is way to small

[blizard05]

Come on Chris,don't give up,you and I both know the DC can do 80+ Wally did it with gas. Go ahead and womp him with an electric set up.

[Punisher 67]

Yup I would consider a bigger hull , a lot bigger...................

[Punisher 67]

This dual motor schematic was done by Racemechanix on our forum here , me and Tyler have worked on some joint projects , this is Seedoobobs mount

now nobody get to excited this has yet to be milled , I should have the run written today and will run it sometime next week............

[dasboata]

This dual motor schematic was done by Racemechanix on our forum here , me and Tyler have worked on some joint projects , this is Seedoobobs mount

now nobody get to excited this has yet to be milled , I should have the run written today and will run it sometime next week............

Nice mount !! I would prefer something I could mount to the rails do you guys ever use rubbers Isolators to mount you motors ??

[Punisher 67]

That mount would bolt to a set of 6" rails , you don't see them in the picture but it would have two mount holes on each end as to be bolted to a stringer system , I have yet to see anyone use rubber isolators for electrics

[dasboata]

I like the mounts BUT there is alot of extra material there you can probleby reduce the size and cut the weight in half also on the alum tubes you might want to concider CF for that WOW effect that's what I would do to mine I already have e mailed Peter Let me see what happens PM me a ball park price I don't need the alum tubs and I would want them reduced down quite a bit what do you think thanks chris

[Punisher 67]

Hello Chris

I am Peter Z..........Why don't you draw up what you had in mind , I also don't work with CF , One day maybe

[dasboata]

Hello Chris

I am Peter Z..........Why don't you draw up what you had in mind , I also don't work with CF , One day maybe

Sorry Peter My mind is blown too much going on can you tell me how the rear of the motor is secured ?

[Punisher 67]

Not a problem Chris

Here is a single 1717 mount , the Castles are a little more difficult because of the wires at the rear

I install a double O- ring buffer at the rear