or was it half a run?
Well, it didn't go so well. Went about 30 feet. Then, nothing. After finally getting it back to shore, full of water, the flex shaft was gone. It was the 3/16 1 pc upgrade shaft from Kintec, along with a 40mm prop, nut, and stainless bullet nut. Kinda sucks, but hey, what are you gonna do
Guess now I know that I have to really tighten that coupler. I didn't want to over-tighten it since everyone is always like "don't make it too tight!" But I guess from now on I'll always put it on just a tad bit tighter. Sucks I have nothing else to report!
Other than the Pursuit, my SV27 ran great. Oh and we used the little brushless Reef Racer 2 to get it back when it flipped from the chop. It's getting way too cold for boating here in NY. I couldn't feel my fingers after getting it out of the water.
Well, it didn't go so well. Went about 30 feet. Then, nothing. After finally getting it back to shore, full of water, the flex shaft was gone. It was the 3/16 1 pc upgrade shaft from Kintec, along with a 40mm prop, nut, and stainless bullet nut. Kinda sucks, but hey, what are you gonna do

Guess now I know that I have to really tighten that coupler. I didn't want to over-tighten it since everyone is always like "don't make it too tight!" But I guess from now on I'll always put it on just a tad bit tighter. Sucks I have nothing else to report!
Other than the Pursuit, my SV27 ran great. Oh and we used the little brushless Reef Racer 2 to get it back when it flipped from the chop. It's getting way too cold for boating here in NY. I couldn't feel my fingers after getting it out of the water.
Comment