Every time I have done what was recommmended by Fluid his suggestions have been correct. I have met him at his boat club in Houston and he has a LOT of experience. You cannot go wrong.
In heat racing I wonder if the Nue 1.5D 2700 Kv motor would be OK to use with 4s power and smaller m445 prop ? It would turn more RPM's for sure
Yes, too many rpm for heat racing unless it is geared - that's a SAW motor. You could oval race it on 3S okay, but on 4S it would overheat the ESC if it didn't wear out the driveline first. That high rpm and a relatively small prop would not hook up well in turns either. Shoot for a 30,000 rpm maximum for heat racing.
.
ERROR 403 - This is not the page you are looking for
Would the x447/3 give a higher top speed?
Im guessing that it would be a little lacking in the turns???
I dont race in an org, I like speed... Lots of it.
I do a little racing with my brother, and a couple of buddies just for bragging rights, but its usually "whos the fastest"
I've run the H7 and a 1450 with a 1415 1y. It's way faster than the spec setup. Unfortunatly running only 1p it puts a lot of stress on the electronics. I ended up taking it out.
Although I never tried any of my 3 blades with the 1415 1y (which was in there for a short amount of time before going back to the spec setup) I did try it with my spec setups. Results weren't as good as the lifter style two blades.
If all of your wishes are granted, many of your dreams will be destroyed!
Comment